AEG OKO FAVORIT 8081 Operating Instructions Manual page 28

28
CJ If the programme is already in the washing stage, ensure that there is still deter-
gent in the dispenser.
(J Set the desired wash programme once more.
Interrupting the Programme:
(J A wash programme in progress is interrupted when you open the door.
CJ Close the door. The wash programme will start again from the point at which
it was interrupted.
CJ Only open the door during the wash cycle when absolutely necessary. By opening
and closing the door cold air enters the dishwasher and quickly heats and expands.
This can cause irregular operation and may require a service call.
Sensorlogic
Should you wish to start your dishwasher with a half or reduced load of dishes, it
features an intelligent Sensorlogic system with fuzzy control. Depending on the
load, the Seensorlogic each time determines the necessary amount of water. A
sensor then initially detects the necessary amount of water depending on the
load of dishes. Few dishes and little soiling call for little water and vice versa. A
sensor then measures the temperature transition when the water is being heated.
This means a short heating time for a small load of crockery and a longer heat-
ing time for a large load. These data are next evaluated by a so-called fuzzy
logic system and the actual load of dishes thereby detected. In the subsequent
programme cycle, your dishwasher now needs only the amount of water required
for a perfect machine result-regardless of how your crockery is arranged.
The power consumption and programme time are of course also correspond-
ingly affected.
At half-load (6 standard place settings), you save up to 3 litres of water and 0.4 kWh
power.
SPE-10 GB/UK-HALB GB/UK