Advertisement
OUT/IN JACK
The auxiliary inputs are line level access points to the three internal mixing busses. They are the medium impedance
type (33K ohms) and are provided to allow parallel mixers or for any other purpose that requires direct signal injection into
the internal mixing busses of the 6018".
LINE CORD
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities.
REVERB FOOTSWITCH
To facilitate remote control of the reverberation function, we have included a remote control footswitch jack. Any
standard single pole footswitch may be used to remotely defeat the reverb function. Please note that this switch disables
the reverb system only and has no effect whatsoever on the effects system.
LINE INPUTS
The line input features phono jacks and allows a signal to be patched directly into the "line to main" and "line to
monitor" controls in the master section. These line inputs are extremely useful when a tape deck needs to be patched into
the system without tying up a desperately needed channel input. Please note that RIAA equalization is not built into this
input. Also note that the dual phono jacks are "bridged" (parallel) allowing a "stereo" signal to be.patched in. Naturally, the
"bridging" reduces this signal to mono.
EFFECTS RETURN
The effects return input on the rear panel may be considered
an auxiliary channel featuring its own set of level
controls located on the front panel. This effects return is capable of handling a wide range of input signals and is a very
high impedance type (220K ohms). The effects return system feeds into both main and monitor mixing busses through the
respective controls and is intended for use when returning signals. from external devices to.be mixed into the main or
monitor outputs.
MAIN AND MONITOR OUTPUTS
The main and monitor outputs are located on the rear panel and are low Z unbalanced. The jacks are 1/4" phone and
each output is capable of 8 volts (18 dBV) out. For sound reinforcement situations, the main output should patch to the
power amp/speaker system for the main PA. The monitor output should patch to the power amp/speaker systeni that is
used for monitors. (See patch diagram.)
REAR PANEL
120 VAC
60 Hz
20 WATTS
OUTPUTS
AUXILIARY
INI
NPUTS
HIGH Z
MAIN
MAIN
LOW Z
MONITOR
MONITOR
BAL.
BAL.
|
EFFECTS
EFFECTS
OUT/IN
QUT/IN
QUT/IN
OUT/IN
O
INPUTS
EFFECTS
REVERB
6
5
4
RETURN
FT. SW.
A PRODUCT OF PEAVEY
VENT THERIS
RISK OF Fie AND SHOCK HAZARD, DONOT
e
e
ELECTRONICS COOP ሾ MENDON, ms
d ሪ
EXPOSE TH HIS
APPLIANCE TO RAIN DR MOISTURE. 'DO NOT
LINE INPUT
|
6
REMOVE
USER SERVICEABLE PARTSINSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONN
MASTER
!
AVIS: RISGUE DE CHOC ELECTRIGUE — NE PAS አች
ORE አክፍቼ
606: ውፍ
1
TYPICAL EACH CHANNEL
oureurs
AX. m
1
'Tan
ta ብይን
MAIN
'
mute 589)
LeveL
MAIN BUS
t
S R hom የ56ወሃ!- 2r)
| MAIN Bus.
MAX 10(922 68
AUX. IN
E
Ww
(0 dev)
wom 19(6 «8ሃ)
MAX BV(^18 8ሃ)
MON. LEVEL
MON. BUS
ልህ. IN
1V
EFFECTS
(0 anv)
ዘዘ 1(9 SBV}
LO .26፡(-12 48ነ)
EFF. US
RECOVERY
REV. RET.
mE
REVERS umr
PEV- DRIVE AMP
T FT. sw.
MAIN BUS.
MON. BUS
REV. TO MON,
$ ^
wm suvise .
898 Ivi env)
MAX 30ሃ(+30 ሀ8ሃ)
MIN BOMV(-26 በ8)
EFF, RET.
Gain AMP
LINE TO MAIN
Guy amp
MAIN BUS:
MAIN BUS
RETURN.
mon.
MON. aus.
MOM vio ጩህ)
"BUS
EFF. TO MON.
SAX 2v(«6 48%)
LIME TO MON.
LINE INPUT
NOM 1V(O dBV)
Advertisement
