U S E R M A N U A L I N D E X 1.0 General warning 1.1 Important safety information 2.0 Etrotek system main features 2.1 How to switch on/off Etrotek system 3.0 Battery 3.1 Battery charge percentage 3.2 How to charge the battery 4.0 Display 4.1 Display control panel...
• Do not immerse the battery into liquids such as water and do not wet the connectors. This may cause overheating, explosions or battery fire. • Use only MONTANA S.R.L. approved battery charger to charge the battery, and respect the requirements indicated for battery charging. Not following these requirements may cause overheating, explosions or battery fire.
U S E R M A N U A L 2.0 ETROTEK SYSTEM MAIN FEATURES To use the ETROTEK propulsion system, make sure that the following requirements are met: • The battery must be sufficiently charged. • The speed sensor must be correctly connected and the magnet correctly positioned.
U S E R M A N U A L CHARGING PLUG FRAME CHARGING SOCKET 3.2 HOW TO CHARGE THE BATTERY • At the moment of the purchase the battery is not completely charged. Before using the e-bike it is necessary to charge the battery completely.
U S E R M A N U A L 4.1 DISPLAY CONTROL PANEL The display is provided with 3 buttons that allow the user to navigate within the software. They can be used either with a short pressing or a prolonged pressing (more than 2 seconds). BUTTON SHORT PRESSING (<...
U S E R M A N U A L SCREEN 3 – TRAVEL TIME This screen displays the travel time (expressed in hours:minutes) from the last reset. SCREEN 4 – POWER This screen displays the power generated by the motor in Watts (W).
U S E R M A N U A L 4.4 WALK MODE The system is provided with a function that allows to activate the motor up to a speed of 6 km/h without pedaling. Press and hold the – button to enter the Walk mode. The motor will enter the Walk mode and the related icon will be displayed on the screen.
• Incompetence, carelessness, negligence or any kind of use that is not compliant with the instructions provided in this manual. • Use of aftermarket parts not approved by MONTANA S.R.L. 4.8 CLEANING AND MAINTENANCE Do not immerse the components into water and do not clean them with high-pressure jets of any kind.
U S E R M A N U A L 4.9 DISPOSAL The disposal of the display, accessories and packaging must comply with the environmental regulations. Before proceeding to the e-bike disposal it is necessary to separate the plastic material from the electrical components, which must be sent to an authorized recycling center as established by the environmental regulations.
Need help?
Do you have a question about the ETROTEK and is the answer not in the manual?
Questions and answers