Table of Contents
Advertisement
10
FCC NOTICE
(For
USA)
Regulatory
This equipment
has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
-
Increase
the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Any
changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void
the
user's
authority to operate the equipment. and For indoor use only, use outdoors or in other modes not covered by this manual may violate the FCC
regulation and violate the user authority to use the product.
FCC Radio Frequency Interference Requirements {for UNII devices)
(For USA)
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference
with and/or damage this device. This device cannot be co-located with any other transmitter.
FCC RF Radiation Exposure Statement
(For USA)
(For having wireless function (WLAN, Bluetooth, ... ))
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmi~er must not be co-located
or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance
20 cm (7.8 inches) between the antenna and your body. Users must follow the specific operating instructions for satisfying RF exposure compliance.
Industry Canada Statement
(For Canada)
(For
having
wireless function (WLAN, Bluetooth, ... ))
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
IC Radiation Exposure Statement
(For Canada)
(For having wireless function (WLAN, Bluetooth, ... ))
This equipment complies with
IC
radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20 cm (7.8 inches) between the antenna & your body.
·
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
Advertisement
Table of Contents
