Advertisement
3
UNDERSTANDING THE EF-X2 MKII
REAR PANEL
A
A. XLR Balanced Input - Fixed line level input. This
input can be used in addition to the input on the front.
The Guitar/Hi-Z and Line Volume knobs on the front
panel do not affect this level.
Please note: this is NOT a microphone level input.
B. XLR Balanced Output - Fixed line level output.
Please note: The signal levels for the rear
XLR I/O is not affected by the front panel volume
knobs or output level switch (M, O and P). Levels can
be trimmed via a mixer or DAW.
B
C. Echo Only - Provides access to the echo only signal
without direct signal or additional effects (Spring
reverb and DSP). Echo mode and feedback settings are
determined by the front panel controls.
D. Effect Only - Provides access to the Spring reverb
and DSP. The output of this jack is determined by the
front panel controls. Please note: When using chorus,
only the wet chorus signal (vibrato) will be heard.
E. Direct Only - Provides access to a duplicate direct
signal after the chosen input preamp (Guitar/Hi-Z or
Line).
E
C
D
F. Auto Tape Stop - If set to ON, the motor and roller
arm will disengage after 4-5mins of not receiving
signal. This increases tape life and reduces wear on the
motor and tape heads. You can disable this feature by
switching it to OFF.
G. Earth Point - For optional alternative grounding.
U SE R MANUAL
G
F
PAGE 8 O F 1 2
Advertisement
