Defrost; Stopping Your Product; Bottle Holder - Beko BSSA300M4SN Instructions For Use Manual

Defrost

A) Fridge compartment
Fridge compartment performs full-
automatic defrosting.
Water drops and a frosting up to 7-8
mm can occur on the inner rear wall of
the fridge compartment while your
refrigerator cools down. Such
formation is normal as a result of the
cooling system. The frost formation is
defrosted by performing automatic
defrosting with certain intervals thanks
to the automatic defrosting system of
the rear wall. User is not required to
scrape the frost or remove the water
drops. Water resulting from the
defrosting passes from the water
collection groove and flows into the
evaporator through the drain pipe and
evaporates here by itself.
Check regularly to see if the drain
pipe is clogged or not and clear it with
the stick in the hole when necessary.
B) Freezer compartment
Deep freezer compartment does not
perform automatic defrosting in order to
prevent decaying of the frozen food.
Defrosting is very straightforward and
without mess, thanks to a special defrost
collection basin. Defrost twice a year or
when a frost layer of around 7 (1/4") mm
has formed. To start the defrosting
procedure, switch off the appliance at the
socket outlet and pull out the mains plug.
When you open/shut the door of the
low-temperature compartment, pull the
closing flap slightly (figure 1).
All food should be wrapped in several
layers of newspaper and stored in a cool
place (e.g. fridge or larder).
Containers of warm water may be placed
carefully in the freezer to speed up the
defrosting. Do not use pointed or sharp-
edged objects, such as knives or forks to
remove the frost. Never use hair dryers,
electrical heaters or other such electrical
appliances for defrosting.
Sponge out the defrost water collected in
the bottom of the freezer compartment.
After defrosting, dry the interior thoroughly
(figure 2).
Insert the plug into the wall socket and
switch on the electricity supply.

Stopping your product

If your thermostat is equipped with "0"
position:
- Your product will stop operating when
you turn the thermostat button to
"0" (zero) position. Your product will not
start unless to you turn the thermostat
button to position "1" or one of the other
positions again.
If your thermostat is equipped with
"min" position:
- Unplug your product to stop it.

Bottle holder

This accessory can be used for storing
bottles or cans side by side.
12 | EN
(figure 1)
(figure 2)