Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Waydoo SUBNADO
Summary of Contents for Waydoo SUBNADO
- Page 1 USER GUIDE|MANUAL|SAFETY V2.0 2022.12...
-
Page 2: Table Of Contents
�� III Waydoo Subnado �� �.� Product Diagram �� �.� Product Specifications �� IV Charging �� �.� How to charge Subnado �� �.� Reverse charging function �� V Assembly Steps �� VI How to use �� VII Product Specifications ��... -
Page 3: I Disclaimer
Any misuse of this product may cause personal injury or property/product damage. When using this product, please be sure to use original accessories or Waydoo certified accessories. By using this product, you are deemed to have accepted the terms and content of this document in its entirety. -
Page 4: Overview
��mm, which significantly reduces the volume of the product. Across the industry, Subnado is the first to use the USB-C charging system, which supports fast charging protocols such as PD �.� and charges up to ���W for fast charging and charging other USB devices. -
Page 5: Waydoo Subnado
III Waydoo Subnado �.� Product Diagram Rear cover Handle Bracket Power switch Propeller Trigger Main unit Waterproof cover �.� Product Feature ◆Two-speed thrust: The high and low gear provides two-speed thrust options. Users can switch to the high or low gear by pressing the trigger twice quickly. -
Page 6: Charging
Idling protection will not be triggered when the device is working underwater. Note: Idling protection will continue to be in effect if Subnado is entering cruise mode in the air. IV Charging �.� How to charge Subnado �. -
Page 7: Assembly Steps
�.� Waterproof cover installed securely in place. �. The waterproof cover keeps water from entering the USB-C port. Improper installation or lack of grease may cause water to enter the USB-C port, and damage to the USB-C port. It is critical to ensure that the USB-C port is free of water. - Page 8 The controller connector is designed to prevent water from entering the connector port. Moisture presenting in the connector port may cause: �. The motor to run nonstop when the Subnado is switched on. �. Nonconductive connector or even permanent damage to the Subnado due to corroded connector pins or contacts.
- Page 9 �. Hold the handgrip and place the Arm mount on the outside of the forearm.Wrap the strap around the forearm �-� times, depending on the arm circumference. �. Fasten the gourd buckle on one end of the strap. �. According to the forearm circumference, wrap it �-� times and finally fix it with nylon tape.
- Page 10 Fix the Subnado leg mount to the outside of the leg. Install the main unit to the leg mount through the quick release part. Note:Please use the specially designed straps for the leg mount. Subnado Leg Mount Fasten the belt around the waist. Pass the straps on both sides of the waist belt through the holes above the leg mount, and then fix them with nylon straps.
- Page 11 �.Let the adhesive cure for half an hour after installation to get a strong bond. �.Install the Subnado to the board mount through the quick-release clamp. Apply a force of about ��N along the Subnado to check whether the board mount is secure before each use.
- Page 12 Installation complete. DO NOT use twin handle bracket with a single Subnado. Note: Please install the wired thumb controller in a dry environment. Please dry the port before installation if it is wet. Please clean and dry the connector and port with cotton swabs or tissue paper before use.
- Page 13 Please use the first screw hole to secure the wrist strap. Warning: To prevent entanglement, please DO NOT use the two rear screw holes to secure the wrist strap. Installation steps for Subnado Water Cannon Kit. hose Nozzle base shell Subnado �.
- Page 14 Please turn off the main unit first. Unscrew the rear cover of the main unit clockwise, remove the O-ring, and take off the propeller. Subnado Finger safe guard O-ring Propeller Rear cover b.
- Page 15 c. Put the finger safe-guard into the groove, press each end of the finger safe-guard into place, and make sure the end of the finger safe-guard is engaged with the notch in the groove (as shown in the figure) d. Check the grease condition. In case the grease is insufficient, please add grease to the optimal amount.
-
Page 16: How To Use
VI How to use This product requires users to be fully familiar with it before use, and users need to have basic knowledge before operating. Waydoo hereby strongly recommends that users read and follow each of the steps before use. -
Page 17: Product Specifications
Plug type Maximum power ���W （PD�.�） �～��℃ （��℉~���℉） Charging temperature Charging time �.�H （���W） Firmware Upgrade: By downloading the Subnado Upgrade Tool from Waydoo official website's "Download" page, users can upgrade Subnado to the latest firmware for better product experiences. -
Page 18: Error And Tone Indication
VIII Error and Tone Indication LED � on the left of the charging port LED � on the right of the charging port �.� Error indication and solution Fault Indicator Fault Solution Place the main unit in an environment of ��-�� degrees Celsius. - Page 19 Fault Indicator Fault Solution Battery Please contact Over-discharge Waydoo support team. Motor Communication Update the firmware Failure �. Use recommended chargers that meet the published charging protocol requirements, such as a charger that PD Communication supports PD/QC protocol. Failure �. If the problem cannot...
-
Page 20: Tone Indication
�.� Tone Indication Tone Indication Main unit Self-checking passes 1 2 3 4 Gear switch: One beep indicates switching to low gear; Two beeps indicates switching to high gear; Three beeps indicates switching to super gear (�s) Unable to enter the setting gear Remind users to power off... -
Page 21: Maintenance
�) Do not store Subnado in humid, direct sunlight and other harsh environments that may cause damage to electronic devices. �) Do not place Subnado in open flames, and please keep out of reach of minors under the age of ��. -
Page 22: Warranty Terms
�) Once your request is received, Waydoo AFS will contact you via e-mail to offer troubleshooting instructions or request further information. �) Waydoo AFS will get back to you via e-mail with instructions on what to do next, depending on their findings. - Page 23 Before obtaining warranty service for your product, please read the following terms and conditions. √ Follow Waydoo's service process; √ Agree that Waydoo shall not be held responsible for the loss or disclosure of any data, including confidential information, proprietary information, or personal information, contained in the returned product;...
- Page 24 × Failure of, or damage caused by, any third-party products, including those that Waydoo may provide or integrate into the Waydoo product at your request. × Products or parts with altered or missing serial number.
- Page 25 Waydoo service availability in different countries/regions where Waydoo product is purchased. √ You may need to send the faulty product(s) back to Waydoo or a Waydoo-authorized service center. Waydoo will examine the returned product(s) to identify the problem and the responsibility upon receipt of the product(s).
- Page 26 Waydoo or related Waydoo authorized service center. An overdue claim will not be accepted.) √ Waydoo reserves the right to update this policy. Check the official Waydoo website for the latest version. Limitation of Liability...
- Page 27 You may have other rights according to the applicable laws of your state or jurisdiction. You may also have other rights under a written agreement with Waydoo. Nothing in this Limited Warranty affects your statutory rights, including rights of consumers under laws or regulations governing the sale of consumer products that cannot be waived or limited by agreement.
- Page 28 Waydoo Technical Support This guide may be updated without notice. Check the official Waydoo website for the latest version www.waydootech.com...
Need help?
Do you have a question about the SUBNADO and is the answer not in the manual?
Questions and answers