Table of Contents
Advertisement
2. INTRODUCTION
This installation and maintenance manual is an integral part of
the heat pump (hereinafter equipment).
The manual must be kept for future reference until dismantling.
It is intended for the specialist installer (installers - maintenance
technicians) and the end user. The manual describes the instal-
lation procedures to be observed for correct and safe operation
of the equipment, and the methods of use and maintenance.
In case of sale or transfer to another user, the manual must stay
with the unit.
Before installing and/or using the equipment, read this instruc-
tion manual carefully and in particular chapter 5 on safety.
The manual must be kept with the unit and always be available
to qualified installation and maintenance personnel.
The following symbols are used in the manual to highlight the
most important information:
Caution
Procedures to be followed
Information / Suggestions
User, Installations and Maintenance Manual
2.1 Products
Dear Customer,
Thank you for purchasing this product.
Our company, always attentive to environmental issues, uses
low environmental impact technologies and materials for its
products, in compliance with EU WEEE standards (2012/19/EU
– RoHS 2011/65/EU).
This product complies with EN12897:2016 standard - Water
supply - Specification for indirectly heated unvented (closed)
storage water heaters.
2.2 Disclaimer
The conformity of these operating instructions with the hard-
ware and the software has been carefully checked. Neverthe-
less there may be differences; and no responsibility is assumed
for total conformity.
In the interest of technical improvement, we reserve the right to
make construction or technical data changes at any time. Any
claim based on indications, figures, drawings or descriptions is
therefore excluded. They are subject to possible errors.
The constructor declines any liability for damage due to com-
mand errors, improper or inappropriate use, or due to unauthor-
ized repairs or modifications.
2.3 Language
The manual was written in Italian (IT), the original language of
the manufacturer.
Any translations into additional languages must be made from
the original instructions.
The Manufacturer is held responsible for the information con-
tained in the original instructions; translations into different lan-
guages cannot be fully verified, therefore, if an inconsistency
is found, it is necessary to follow the original language text or
contact our Technical Documentation Office.
Page 7
Advertisement
Table of Contents
Troubleshooting
