Hawke 151 RAC Assembly Instructions

Cable Gland Assembly Instructions
151 RAC
A: Component Parts
B: Cable Preparation
Slide shroud (if included), backnut , middlenut  and armour clamp ring  onto cable.
Con rm orientation of armour clamp ring is correct (see table below).
Cut cable length, strip outer sheath and cut armour to lengths as shown in table below.
y
Strip Lengths
Gland Size
Dim
Os-C C2-F
x
20mm 25mm
y
To suit equipment
Tape Armour
After tape is spread, ensure ends are
trimmed at 90° as shown
AI393 - Issue H / Page 1 of 4
1 Entry
x
G-J
32mm
x
3
2 Spigot
3 4 5
4 Middlenut
Armour Clamp Ring
Shroud
(If applicable)
Armour Clamp Ring Orientation
Orientation
Gland
Size
Equipment Side
Os-A 0.8 - 1.25mm
B 1.25 - 1.6mm
C-C2 1.6 - 2.0mm
D-F 1.8 - 2.5mm
G-H 2.0 - 3.5mm
J 2.5 - 4.0mm
5 Backnut
Equipment Side
0 - 0.8mm
0 - 0.7mm
0 - 0.7mm
0 - 1.0mm
0 - 1.0mm
0 - 1.0mm