Panasonic EW3109 Operating Instructions Manual page 17

STORING MEASUREMENT VALUES
This product can store up to 90 measurement values.
*Stored data will remain in memory even if batteries become exhausted or
batteries are removed.
After measurement, DI'eSS the 记忆 / 调 出
button while the (MJ mark is blinking.
最 高 血压 mmHg 最 低 血压 mmHg
Panasonic
"im no «s EE
(atl! pa a "ac Sv
kPa kPa 脉 捕 数 /分
Storing is completed.
* Up to 90 measurement values can be stored.
When the memory is full and additional values
are stored, the oldest value in memory will be
deleted and the new value will be stored.
e lf measurements could not be taken properly
(the E mark is shown instead of the blood
pressure value), measurement values cannot
be stored.
* However,even if the E mark is shown for the
pulse value, the blood pressure value will be
stored.
Panasonic
最 高 血压 mmHg
"最 低 血 压 。 mmHg
=, umm, --- «m, ^ =
—-| 120^ m^ ss» 开始
(tL! UN DN bc 结束
kPa a 脉搏 数 / 分
Number of stored data
To erase all measured values stored in memory:
1.Press the 记忆 / 调 出 button to recall stored measurement values.
2.Press the 记忆 / 调 出 button again and hold it pressed until the
measurement values disappear (longer than approximately 3 seconds).
* ltis not possible to erase single measurement values.
To switch off the blood pressure monitor,
press the 开始 /结束 button.
* If you forget to switch off the blood pressure
monitor ,it will switch off automatically after
approximately 5 minutes.
开始
paj
1 A
31
RECALLING STORED MEASUREMENT VALUES
Measurements can be recalled after measurement is completed or
after the power has been switched off.
If no measurement values are stored, no value will be shown.
Press the 记忆 / 调 出 button.
1 The average of all measured
values in memory wil be Shown.
出 e @ will be shown at the top right of the
display.
e For example, if 90 measured values are
stored, the average of 90 measurements
will be shown.(If only 1 measurement is
stored, the mark will not be shown.)
最 低 血 压 mmHg
me Ao 开始
(um or n 结束
kPa kPa 脉搏 数 /分
2 Press the 记忆 / 调 出 button again.
Each time you press the 记忆 / 调 出
button, the previously stored measurement
: values will be SHOWN in order, starting
7 BE with the newest data.
Press the 记忆 / 调 出 button lightly for only a short
time.If you hold the button pressed for approximately
3 seconds or longer, all data in memory will be
erased, so please be careful.
最 低 血压 mmHg
Panasonic
* [a30 QI. «xp BE
(tL LI bc 结束
kPa kPa 脉 捕 数 /分
Press the 开始 /结束 button.
* If you forget to switch off the blood
pressure monitor, it will switch off
automatically after approximately
30 seconds.
3 To cancel measurement value recall,
32