Table of Contents
Advertisement
/-For West Germany-\
Bescheinigung des Herstellers/lmporteurs
Hiermit wird bescheinigt, daB der/die/das
in Ubereinstimmung mit den Bestimmungen der
digital multi echo RE-iooo
Amtsbl. Vfg 1046/1984
(Gerat. Typ. Bezeichnung)
(Amtsbiattverfugung)
funk-entstort ist.
Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerates angezeigt und die Berechtigung zur Uberprufung
der Serie auf Einhattung der Bestimmungen eingeraumt.
Roland Corporation Osaka/Japan
Name des Herstellers/lmporteurs
___
'
-
r—
-—-For the USA-\
RADIO AND TELEVISION INTERFERENCE
WARNING —
This equipment has been verified to comply with the limits for a Class B computing device, pursuant to Subpan J of Part 15 of FCC rules Operation with
non-certified or non-verified equipment is likely to result in interference to radio and TV reception
The equipment described in this manual generates and uses radio frequency energy. II it is not installed and used properly, that is. m strict accordance with our instructions,
it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B computing device in accordance
with the specifications in Subpart J, of Part 15, of FCC Ruies. These rules are designed to provide reasonable protection against such a interference in a rasidential installation
However, there is no guarantee that the interference will not occur in a particular installation If this equipment does cause interference to radio or television reception, which
can be determined by turning the equipment on and off. the user is encouraged to try to correct ihe interference by the following measure
• Disconnect other devices and their input/output cables one at a time II the interference stops, it is caused by either the other device ot its I O cable
These devices usually require Roland designated shielded I/O cables For Roland devices, you can obtain the proper shielded cable from your dealer Foi non Roland
devices, contact the manufacturer or dealer for assistance.
If your equipment does cause interference to radio or television reception, you can try to correct the interference by using urn? m more ol the following measures
• Turn the TV or radio antenna until the interference stops.
• Move the equipment to one side or the other of the TV or radio
• Move the equipment farther away from the TV or radio.
• Plug the equipment into an outlet that is on a different circuit than the TV or radio. (That is. make certain the equipment and the radio or television set are on circuits con¬
trolled by different circuit breakers or fuses.)
• Consider installing a rooftop television antenna with coaxial cable lead-in between the antenna and TV If necessary, you should consult your dealer or an experienced
radio/tetevision technician for additional suggestions. You may find helpful the following booklet prepared by the Federal Communications Commission
"How to Identify and Resoive Radio — TV Interference Problems'
This booklet is available from the U.S. Government Printing Office. Washington. D-C-. 20402. Stock No. 004-000-00345-4.
v,___
For Canada-\
CLASS B
NOTICE
This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communications.
CLASSE B
AVIS
Cet appareil numerique ne depasse pas les limites de la classe B au niveau des emissions de bruits radioelectriques fixes
dans le Reglement des.signaux parasites par le ministere canadien des Communications.
Printed in Taiwan '90-4-E3-11Y
Products of Roland
Advertisement
Table of Contents
