Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Boss MR1515W
Summary of Contents for Boss MR1515W
- Page 2 Congratulations on your purchase of a Audio Systems Compact Disc Receiver. This product has been designed and built to deliver the highest quality audio reproduction while impervious to the harsh conditions of the marine environment. We are sure you'll enjoy listening to your favorite music with this component as part of your car audio system.
-
Page 3: Table Of Contents
CONTENTS Installation .....................4 DIN Front-Mount....................4 Installing the unit.....................4 Removing the unit...................5 Using the Detachable Front Panel .............6 Wiring Connection ..................7 Marine Remote....................8 Operation.....................11 General Operation ....................11 Radio Operation ....................13 CD Operation ......................14 CD Changer Operation ..................15 Specification....................16 Trouble Shooting..................17... -
Page 4: Installation
INSTALLATION Notes: TRANSPORT SCREWS Before installing the unit remove the two Read this entire manual before you transport screws on the top of the unit begin installation. chassis. • This unit is designed for use in boats. Its water resistant design makes it a Take out screw before installation good choice for other vehicles (such as off-road) that may be exposed to... -
Page 5: Removing The Unit
INSTALLATION Removing the unit Front Panel OPEN button (Fig. 2) 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5x25mm) 5. Screw 6. Strap Be sure to use the strap to secure the back of the unit in place. The strap can 1. -
Page 6: Using The Detachable Front Panel
USING THE DETACHABLE FRONT PANEL To Detach the Front Panel To Reinstall the Front Panel 1. Press the OPEN button, the front panel 1. When the panel bracket is in slide down will slide down. position, insert the front panel into the panel bracket and push the front panel from the middle to slide it up. -
Page 7: Wiring Connection
WIRING CONNECTION MAIN UNIT (BLACK) WIRED REMOTE ANTENNA SOCKET CONNECTOR (BLACK) CD CHANGER CONNECTOR IGNITION FUSE SWITCH (YELLOW) (+)12V (ACC) Rch RED AUX IN Lch WHITE YELLOW CONSTANT 12 VOLTS (BROWN) Rch RED FRONT RCA CABLE BLACK GROUND (B–) Lch WHITE (GREY) Rch RED REAR RCA CABLE... -
Page 8: Marine Remote
CONTROL & FUNCTIONS KEYS This unit is a marine rated wired remote control made using a modified controller or similar layout. It is capable of operation specified functions on the marine AM/FM/CD receiver and the marine AM/FM receiver. The body, buttons, controls and display need to be UV and water-resistant. - Page 9 INSTALLATION 6 TRACK/SEARCH/TUNE buttons • STATION SELECTION (FOR RADIO OPERATION) Press buttons (6) shortly to activate automatic seek function. Press for more than 3 seconds until “MAN” appears on the display, the manual tuning mode is selected. If both buttons have not been pressed for several seconds, they will return to seek tuning mode and “AUTO”...
- Page 10 INSTALLATION Select the proper position to install the remote controller and then cut a hole with the diameter about 88mm. Then use mounting bracket and two screws to install the controller to the board. Be sure to place the rubber washer and rubber ring between the controller and the board.( Please refer to the following picture.) MOUNTING BRACKET RUBBER RING...
-
Page 11: Operation
OPERATION • SOUND ADJUSTMENT GENERAL OPERATION Press SEL button (10) to select desired audio mode. • ON/OFF The adjustment mode will change in Switch on the unit by pressing POWER the following order. button (9). When system is on, press POWER button (9) again to turn off the Volume Bass... - Page 12 OPERATION Press and hold SEL button for 2 • Frequency Priority seconds to turn this function on/off. Press and hold DISP button (1) while pressing button (17) to select Frequency Priority. • LOUDNESS Pressing DISP button (1) while in Press LOUD/DIM button (15) to Frequency Priority will temporarily enhance bass response at low volume display clock.
-
Page 13: Radio Operation
OPERATION RADIO OPERATION • SCAN Press SCAN button (13) to scan through strong stations in the current • BAND SELECTION band. Radio pauses for five seconds In tuner mode press the BAND button at each strong station. At each time to select the desired band. -
Page 14: Cd Operation
OPERATION CD OPERATION 2. Press button (16) or button (17) to choose track number. For example, select track 6, then press • SELECT TRACKS MEM button (20) for few seconds Press button (16) or button (17) to to memorize it and “P-02” will move to the previous track or the appear on the display. -
Page 15: Cd Changer Operation
OPERATION CD CHANGER OPERATION Note: • SELECT TRACKS A. Notes on discs: Press button (16) or button (17) to 1. Attempting to use non-standard shape move to the previous track or the discs (e.g. square, start, heart) may following track. Track number shows damage the unit. -
Page 16: Specification
SPECIFICATION GENERAL Power Supply Requirements : 12 Volts DC, Negative Ground Chassis Dimensions : 178 (W) x 178 (D) x 50 (H) mm Tone Controls - Bass (at 100 Hz) 10 dB - Treble (at 10 KHz) 10 dB Maximum Output Power : 50 Watts x 4 channels Current Consumption : 15 Amperes (max.) -
Page 17: Trouble Shooting
TROUBLE SHOOTING If the power wire is properly connected to the vehicles ACC circuit while the engine is not running, turn the key to the ACC position. Symptom Cause Solution No power. The car ignition switch is If the power wire is properly not on. - Page 18 88-C1801-08...
Need help?
Do you have a question about the MR1515W and is the answer not in the manual?
Questions and answers