Universal Innovations PROVENCE User Manual

Dear Customer,
We tried to achieve two targets when developing this product.
The first was to produce the best quality heater on the market.
The second was to produce the most cost-effective heater.
We feel that we have achieved these two objectives however we
would be delighted to hear from you if you have any comments.
Thank you for purchasing one of the products in our
range. We wish you many enjoyable warm hours.
Yours Sincerely
Chairman
GUARANTEE
The Provence gas stove is made by Universal Innovations. It is made to an
exacting quality standard and is covered by the following guarantee:
THIS PRODUCT IS FULLY GUARANTEED FOR 2 YEARS,
REGARDING PROPER USE.
This guarantee does not affect your statutory rights in any way.
HELPLINE Dublin Ireland
00 353 1 2873797 or at www.saharabbqs.com
IF YOU NEED ANY ASSISTANCE PLEASE DO NOT HESITATE TO CONTACT US
DIRECTLY AT THE FACTORY. DO NOT BRING GOODS BACK TO PLACE OF
PURCHASE.
USER INSTRUCTIONS
Read the instructions before using this appliance.
When lighting for the first time, burn on high in a very well ventilated area for 4 hours minimum to
cure the synthetic logs (The logs give off an odour when curing).
Flame colour is yellow when turned on for the first time.
The appliance must be installed and used in accordance with the regulations, which are
currently in force.
The heater should be positioned on a level surface. Use only in a well ventilated area.
The minimum room size when using this appliance is 64 cubic metres with a minimum
ventilation of 80 cm squared area.
To fit a Butane Gas Regulator:
Attach regulator to end of hose and secure with hose clip.
Note: for ease of fitting hose, lubricate ribbed nipple of regulator with a soap solution.
To fit a Butane Gas Cylinder:
(Ensure that the area is free from any unprotected combustible material or substance)
Containers should be changed in accordance with instructions provided.
1. The changing and connection of LPG cylinders must be undertaken in a flame free
atmosphere.
2. Attach the regulator to the new cylinder. Ensure that the hose is not twisted or damaged in
any way.
3. Use gas cylinders with a gas capacity of 7-15kgs.
4. In order to remove the regulator you must ensure that the regulator is in the "off" position.
Before lighting:
1. Inspect the hose assembly. If the hose is cut or shows signs of excessive wear, or is leaking it
must be replaced prior to operation of the heater.
2. Ensure the heater is positioned with a minimum clearance above and beside of 0.6metres
from flammable materials both vertically and horizontally.
3. Ensure that the stove door is closed securely.
P
ROVENCE
Flueless Gas Stove
User Manual
IE/GB
USER INSTRUCTIONS
To Light Heater:
1. Fit battery type AAA provided into ignition button ("+" side up).
See Fig.1. Remove battery during periods of non-use to
prevent battery leak.
2. Turn on gas supply at gas cylinder regulator.
3. Push control knob down and turn the control knob to the
position and at the same time, press sparker button to light
the pilot while continually holding down control knob.
4. If there is no spark, check the battery type AAA is correctly fitted.
The pilot flame can be viewed at the right hand side of the
log bed.
5. If pilot does not light, turn control dial to
minute and repeat step 3. Do not continuously hold down the
control knob as you may cause a build up of gas.
6. Once the pilot is lit, continue holding down the control dial for
at least 10 seconds until the main burner lights.
Operate the fire between the high and
settings as required.
7. If the pilot and main burner do not stay lit on releasing the
control knob, turn the control knob to the ignition position
and repeat steps 3 to 4.
8. The is a pilot setting only.
To Turn Off Heater:
1. Turn the control knob to position.
2. After use turn off the appliance at the gas container valve.
NOTE: The pilot light will remain alight until the cylinder
regulator is turned off.
3. Disconnect the regulator from the cylinder when the heater is
not in use.
4. Remember to remove battery during periods of non-use to
prevent battery leak.
Important:
Read all of the instruction Manual before using this
appliance. This appliance must be installed in accordance with
such regulations as are in force. Installation to be carried out by a
competent person.
Warning: The guard (glass door) on this appliance is to prevent
risk of fire or injury from burns and no part of it should be
permanently removed. IT DOES NOT GIVE FULL PROTECTION FOR
YOUNG CHILDREN OR THE INFIRM. For the full protection of
young children or the infirm, we recommend a fireguard
conforming to BS 8423 be fitted.
Manufactured by Manufactured by
696
Fig.1
Unscrew ignition button
to fit battery 1.5V
type AAA
position. Wait one
Fig.2
low flame
pilot light
Note: when lighting,
the pilot light must be a
steady flame.