Use of the 1.25" to 1.5" Hose Adapter
Note: These instructions are only applicable if the Hose Adapters are included in the accessories
pack of the filter pump packaging.
If the diameter of the Filter Pump Inlet/Outlet or Pool Fittings (1.25") do not match with the diameter of the hose (1.5"),
take out the Hose Adapters from the accessories pack and follow the steps below for installation.
1. 1.25" to 1.5" Hose Adapter is shown below:
2. Installation Procedure:
1) Take out the Filter Pump Assembly, two Hoses, four Hose Clamps and
four Hose Adapters.
* Filter pump image for reference only
3) Insert another Hose Adapter to the other end of the hose and then,
connect the hose to the Suction Fitting of the pool.
Replacement parts ordering info
Key #
1
a.
b.
Description
Hose Adapter x 1
2) Add a Hose Clamp on each end of the hose. Insert a Hose Adapter
to one end of the hose and then, connect the hose to the Filter
Pump Inlet.
a.
b.
4) Tighten the Hose Clamps to prevent loosening and water leakage.
Repeat steps 2, 3 & 4. Connect the Return Fitting to the Filter
Pump Outlet (sequence as shown below).
PART #
P58PF5620P01
1