Toro Z Master Professional 7500-D Series Operator's Manual page 9

126-8760
For Models with 244 cm (96-inch) Decks
1. Height of cut
1. Read and understand the Operator's Manual before servicing
the machine.
2. Time interval
3. Check the engine-oil level.
4. Check the coolant level; refer to the Operator's Manual for
further instructions.
5. Check the tire pressure (2 locations).
6. Check the hydraulic-fluid level; refer to the Operator's Manual
for further instructions.
decal126-8760
2. Range adjustment
For Models with 244 cm (96-inch) Decks
1. Front of deck
1. Chassis (15 A)
2. Accessory (15 A)
126-9947
7. Check the oil level in the jackshaft.
8. Grease the deck drive PTO; refer to the Operator's Manual
for further instructions.
9. Check the air cleaner.
10. Grease the idler pivots (3 locations); refer to the Operator's
Manual for further instructions.
11. Grease the front caster wheel bearings (4 locations); refer to
the Operator's Manual for further instructions.
12. Grease the front caster pivots (5 locations); refer to the
Operator's Manual for further instructions.
9
126-9127
126-9351
3. Main (25 A)
4. Power point (15 A)
decal126-9127
decal126-9351
decal126-9947