Panasonic LX600E Operating Instructions Manual page 23

Digital Out
Headphone
Balance
Reset
Network Menu Content
Network Type
Scan Wireless
Networks
Disconnect
Press WPS on your
wifi router
Internet Speed Test
Advanced Settings
Networked Standby
Mode
Note: For detailed information on the options of this menu refer to the Connectivity section.
Sets digital out audio type.
PCM: This option provides two-channel uncompressed digital audio output. You can
use this option if you experience compatibility problems such as not hearing sound.
Auto: This option provides multi-channel digital audio output (up to 5.1 channel).
Passthrough: This option provides original audio output as such in HDMI ARC. It is
recommended to use this option if you have an A/V receiver with eARC support. If your
A/V receiver does not support source audio format you may experience compatibility
problems such as not hearing sound.
Sets headphone volume. This option will not be available if the Sound Output option
is set as Lineout.
Please ensure before using headphones that the headphone volume is set to a low
level, to prevent damage to your hearing.
Sets sound balance. This feature will be activated if Sound Output option is set as TV
or Headphone Only. Balance item adjusts the balance level of the TV speakers and
headphones together.
Resets some of the sound settings to factory defaults.
Disable the network connection or change the connection type.
Start a search for wireless networks. This option will be available if the Network Type
is set as Wireless Device.
To disconnect from a wireless network and delete your saved wireless network profile (if
previously saved), highlight this option and press OK. This option will not be available
if you did not connect to a wireless network. Refer to Connectivity section for more
information.
If your modem/router device has WPS, you can directly connect to it using this option.
Highlight this option and press OK. Go to your modem/router device and press the
WPS button on it to make the connection. This option will be available if the Network
Type is set as Wireless Device.
Start a speed test to check your connection bandwidth. The result will be displayed on
the screen when finished.
Change the IP and DNS configurations of your TV.
Enable or disable this feature by setting it as On or Off.
English - 22 -
PCM, Auto, and Passthrough options will be available.