Minolta X-700 Instruction Manual page 58

56
MOTOR DRIVE 1 and AUTO WINDER G
With Motor Drive 1 attached , you can capture the action with single-frame
or continuous operation at either 2 or 3.5 frames per second . The comfortable
handgrip has two operating buttons, each with a Minolta "touch switch",
enabling full viewfinder readout for either horizontal or vertical framing.
Auto Winder G lets you focus full attention on the creative aspects of
photography by freeing you from winding the film after each picture.
Continuous sequences up to 2fps are also possible by holding the camera's
operating button down .
Both units are designed to attach quickly and easily without access caps to
remove or store. Their film-advance mechanisms stop automatically at the end
of the roll , and film can be easily loaded and unloaded without removing the
units.
WIRELESS CONTROLLER IR-1 SET
The I R-1 infrared transmitter/ receiver set lets you trigger the X-700 from
up to GOm (about 200 ft . ) away for remote-controlled single-frame exposures,
continuous sequences, or time exposures. When used with extra receivers, the
three-channel transm itter enables independent operation of up to three
cameras or groups of cameras, or simultaneous operation of an unlimited
number of cameras.