Table of Contents
Advertisement
RX-1180, RX-1190
Antenna ground
Although grounding is not necessary for reception it is recom-
mended for protection against damage from lightning if an out-
door FM antenna is used. Grounding is recommended as well
to help reduce noise and hum.
NOTE:
Never make the ground connection to a gas pipe as sparks could
cause the gas to ignite.
NOTE ABOUT SPEAKER CONNECTIONS
©
Speaker systems used should have an impedance of be-
tween 82 and 162.
¢
Be sure that connections are secure. Check to make sure
that wires do not protrude from their terminals.
¢
Do notallow the speaker cords to become shorted.
Damage may result to your equipment.
To control a unit other than this receiver using the re-
mote control unit
@® In the case of a PIONEER equipment marked 8] which is
provided with a remote sensor, operate the equipment by
aiming the remote control unit at the remote sensor on the
equipment.
@ For
equipment
with
the Fal mark,
but without
a remote
sensor, operation of the equipment by facing the remote con-
trol unittowards the remote sensor of the cassette deck receiv-
er possible with connection from the CONTROL OUT jack to
the CONTROL IN jack. Use a commercially available cable with
mini-plugs for the connection.
4. PANEL
FACILITIES
(@
©
Do not attempt to simultaneously connect two sets of
speakers to a single side (A or B). When using two sets of
speakers, connect one set to side A and one set to side B.
AC OUTLET
SWITCHED
100W MAX
Power supplied through this outlet is turned on and off by this
equipment's POWER switch. Total electrical power consump-
tion of connected equipment should not exceed 100 W.
NOTE:
Do not connect appliances with high power consumption such
as heaters, irons, or television sets to the AC OUTLET, inorder
to avoid overheating or fire risk.
This can cause this equipment to malfunction.
IN
IN
OUT
Cw
ChE
NTROL
co
CONTROL
CD player
Equipment with
the {fq} mark.
Cassette deck receiver
©
—
N
al
Advertisement
Table of Contents
