Toro 72076 Setup Instructions page 3

1. Full line
8. Replace the dipstick and thread the fill cap
finger-tight onto the filler neck.
9. Check all hoses and fittings for leaks.
5
Checking the Deck
Gearbox-Fluid Level
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Lower the mower deck to the 2.5 cm (1 inch)
height of cut.
3. Disengage the blade-control switch, move the
motion-control levers to the N
position, and engage the parking brake.
4. Shut off the engine and remove the key.
5. Raise the deck-lift pedal to expose the top of the
mower deck.
6. Remove the dipstick/fill plug from the top of the
gearbox and ensure that the lubricant is between
the marks on the dipstick
Figure 2
2. Add line
-L
EUTRAL OCK
(Figure 3).
g228816
1. Dipstick/fill plug
7. If the fluid level is low, add fluid until the level is
between the marks on the dipstick.
Important:
overfilling the gearbox may damage it.
6
Checking the Wheel Lug
Nut Torque
No Parts Required
Procedure
Before you start the engine and use the machine,
check the wheel lug nut torque; refer to Checking the
Wheel Lug Nuts in the Operator's Manual
3
Figure 3
Do not overfill the gearbox;
g231764