Advertisement
e. Press ENTER. The receiver automatically fine tunes the new satellite position. The
"Auto-Skew" and "Auto-ANT." messages flash on screen. The flashing stops when the
process is complete.
f. Repeat steps 6.b through 6.e for each satellite in turn, moving eastward, until you have
entered all the desired satellites. When the last satellite has been entered, the receiver
must be put back in Auto Mode.
g. Press FUNCTION.
h. Select No. 4, Receiver Mode.
i. Select No. 1, Auto.
j. Press ENTER. The receiver is now in Auto Mode. Any of the programmed satellites
may be called by pressing the "C-SAT" key (Ku-SAT, if a Ku satellite), followed by the
2 digit satellite name.
Main Functions List TRX 1420
PROGRAM MODE
1. SET UP
1.1 Channel Scan
1.2 Auto Tuning
1.3 Input Mode
2. CHANGE PROGRAM
2.1 Change Polarity/Skew
2.2 Channel Fine Tuning
2.3 Change Antenna Limit
3. INSTALLATION
3.1 Ku-Sat Format
3.2 Calibrate Ku Channel
3.3 All Data Clear
4. RECEIVER MODE
To access any of the functions, put the receiver into the desired mode (Auto or Program), then
press the FUNCTION key. If you can not access the Program Mode, you must disable the
Parental Control.
TRX 1420
1. CUSTOMER CHOICE
1.1 Basic OSD
1.2 Antenna Move Blank
1.3 Skip Tuning
2. CHANGE PROGRAM
2.1 Change Polarity/Skew
2.2 Channel Fine Tuning
2.3 Channel Skip
2.4 Audio Program
2.5 Category Selection
2.6 Favorite Program
2.7 Realign Satellite Memory
3. PARENTAL CONTROL
3.1 PL Enable/Disable
3.2 Antenna Lock
3.3 Channel Lockout
3.4 Change Password
4. RECEIVER MODE
6
AUTO MODE
Advertisement
