Table of Contents
Advertisement
DST-3000 Receiver's Menu System
Tag Boxes
The four columns of small boxes on the right hand side of the CHANNEL LISTS screen are the
Tag Boxes. The first three columns are the lists traditionally known as Fav. A, Fav. B, and Fav. C.
The fourth column is the Family list.
In the CHANNEL LISTS screen, use the , , , and
L
keys to highlight the button that
L
corresponds to the channel number and list that you wish to change. Press the
key to add
SELECT
or remove the check mark, which indicates that the channel in that row is included in the list
shown at the top of the column.
To help you decide whether to include or exclude a certain channel, the title of the currently
airing program for that channel will appear at the top of the screen.
Locking is described in the subsection "Lock/Unlock" later in this chapter. When the system is
locked, the passcode will be needed to modify the settings of the channel lists.
MyLogos™
Highlighting the MyLogos button on the SETUP
screen and pressing the
key on the remote
SELECT
control displays the MYLOGOS SETUP screen
shown to the right.
On the left are buttons for Done and Video, which are
explained below.
Done
Highlighting the Done button on the screen and
pressing the
key on the remote control causes
SELECT
The MyLogos™ setup screen
an exit from the MYLOGOS SETUP screen and a
return to the SETUP screen.
Video
Highlighting the Video button on the screen and pressing the
key on the remote control
SELECT
will return you to the last program you were viewing.
The MYLOGOS SETUP screen is used to specify which nine channels will appear in the
MyLogos pop-up panel that displays when
is pressed.
SELECT
Set Channel
Using the , , , and
L
keys, highlight one of the nine channel boxes. You can enter the desired
L
channel using the number keys on the remote control or by using the
and
keys. Pressing
while highlighting one of the channel boxes will also initiate a pop-up panel that will
SELECT
allow you to set the channel using the
L
and
keys on the remote control or the DST-3000
L
receiver's front panel.
Installation
Highlighting the Installation button on the SETUP screen takes you to the INSTALLATION
screen, which contains utilities to facilitate installation of your satellite dish antenna. You can
also evaluate your system's signal strength via the INSTALLATION screen. This screen was
discussed in detail in Chapter 4, "Setting Up the Satellite Dish Antenna and Terrestrial Inputs."
Page 7-11
Advertisement
Table of Contents
