Table of Contents
Advertisement
Toshiba DST-3000 High Definition Digital Receiver
Filters
The default setting for Filters is "Temporary." With a setting of "Temporary," each time you
leave the on-screen guide, all filters other than the Channel List will reset "All Categories" and
complete class. If you change the Filters setting to "Persistent," any filtering that you should
happen to do will survive exiting the on-screen guide and be in effect for the Banner Guide and
even later when returning to the on-screen guide at a later time.
Translucency
The TRANSLUCENCY option allows you to set the degree of translucency in menus and
screens that overlay video.
Advanced Preferences
Highlighting the Advanced button on the
PREFERENCES screen and pressing the
key
SELECT
on the remote control will display the ADVANCED
PREFERENCES screen shown at right. This screen
contains additional preferences that are less likely to
require changes once they are selected. Most users
will not make any changes to this screen. This screen
also provides a means to reset all preference settings
to the factory default settings.
Done
The ADVANCED PREFERENCES screen
Highlighting the Done button on the screen and
pressing the
key on the remote control causes
SELECT
an exit from the ADVANCED PREFERENCES screen and a return to the PREFERENCES
screen.
Video
Highlighting the Video button on the screen and pressing the
key on the remote control
SELECT
will return you to the last program you were viewing.
Advanced Preference Options
On the right of the ADVANCED PREFERENCES screen is a panel of option buttons and their
related current settings: Receiver ID, Channel Lock, and Factory Defaults, which are explained
below.
Receiver ID
Someday, you may choose to get a second DST-3000 receiver. If both receivers are in the same
room or if you are using an RF remote control or a remote control extender, you may experience
interference between signals. To avoid this "cross talk," simply highlight the Receiver ID button
and press
on the remote control to be used for that specific DST-3000 receiver. Remember
SELECT
to set your remote control to the desired code first. For information regarding changing the
remote control code, see Chapter 8, "Programming Your Remote Control."
Page 7-4
Advertisement
Table of Contents
