Panasonic PT-L511U Service Manual page 32

6.6.3. Equipment to be used
PC, Software for Adjustment
6.6.4. Adjustment Procedure
1. Display the flicker adjustment menu.
2. Set the installation mode to the desk setting.
3. Click "R Signal Adj," and the red flicker adjustment pattern will be
displayed.
4. Minimize the flicker while observing the projected pattern.
5. Click "G Signal Adj," and the green flicker adjustment pattern will
be displayed.
6. Minimize the flicker while observing the projected pattern.
7. Click "B Signal Adj," and the blue flicker adjustment pattern will
be displayed.
8. Minimize the flicker while observing the projected pattern.
9. Change the installation mode to the ceiling setting and follow
steps 3 to 8 inclusive.
6.7. Input Level Adjustment
6.7.1. Adjustment Menu
6.7.2. Explanation of Buttons
OK:
Executes automatic sub contrast and sub brightness adjustments, then closes this dialog.
Cancel:
Cancels this menu.
6.7.3. Equipment to be used
PC, Software for Adjustment, Signal Generator
6.7.4. Adjustment Procedure
25