Advertisement
thermOweld
INSTRUCTIONS FOR THERMOWELD GROUNDING CONNECTIONS - STUD TO RAIL
RX-1
Follow procedures on back of this sheet for preparation
of rail and stud. Cut stud end at 25° and butt against rail
for maximum strength. Position mold on cleaned rail and
secure to rail with "C" clamp. Follow welding procedures
on the back of this sheet.
RX-2
Follow procedures on back of this sheet for preparation
of rail and stud. Cut stud end at 25° and butt against rail
for maximum strength. Follow welding procedures on the
back of this sheet.
+1 (918) 627-5210 • 1-800-558-1373 • WWW.THERMOWELD.COM
ELECTRICAL GROUNDING • CATHODIC PROTECTION • ELECTRIC UTILITY • RAIL
®
The Contractors Choice
Tel. +1.800.558.1373
Tel. +1.918.627.5210
www.thermoweld.com
ECN 2552 REV "F" 03/06/13
34-5381-94
Advertisement
Table of Contents
Related Manuals for Burndy Continental Industries thermOweld RX-1
Summary of Contents for Burndy Continental Industries thermOweld RX-1
- Page 1 thermOweld ® The Contractors Choice INSTRUCTIONS FOR THERMOWELD GROUNDING CONNECTIONS - STUD TO RAIL RX-1 Follow procedures on back of this sheet for preparation of rail and stud. Cut stud end at 25° and butt against rail for maximum strength. Position mold on cleaned rail and secure to rail with "C"...
- Page 2 GENERAL SAFETY INSTRUCTIONS WELDING PROCEDURE 1. Check mold tag for material to be welded and proper cartridge 1. Always wear proper clothing, safety glasses and gloves when size to use. exothermic welding. 2. Make sure all surfaces and conductors are clean, dry and are 2.
Need help?
Do you have a question about the Continental Industries thermOweld RX-1 and is the answer not in the manual?
Questions and answers