Polaris Hawkeye 325 2X4 2016 Owner's Manual For Maintenance And Safety page 141

Handlebars
The handlebars can be adjusted for rider preference.
WARNING! Improper adjustment of the handlebars or incorrect torquing of the
adjuster block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control and serious injury or death. Follow the
adjustment procedures exactly, or see your POLARIS dealer for service.
1. Remove the upper headlight pod.
2. Loosen the four handlebar bolts.
3. Adjust the handlebar to the desired
height.
4. Be sure the handlebars do not contact the
gas tank or any other part of the machine
when turned fully to the left or right.
5. Torque the front two bolts to 10-12 ft-lbs
(14-17 Nm), then torque the rear two
bolts. A gap of up to 1/8" (3 mm) will
remain at the rear of the clamp blocks.
Camber and Caster
The camber and caster are non-adjustable.
Rear Spring
The rear shock absorber spring is adjusted by
rotating the cam either clockwise or counter-
clockwise to increase or decrease spring
tension.
Front Spring (570 SP Models)
The front shock absorber spring is adjusted by
rotating the cam either clockwise or counter-
clockwise to increase or decrease spring
tension.
MAINTENANCE
Handlebar
Bolts
Cam
High
Tension
Low
Tension
139