Subscribe to Our Youtube Channel
Related Manuals for KRESS KC711 Series
Summary of Contents for KRESS KC711 Series
- Page 1 SAFETY AND OPERATING MANUAL Commercial 60V 51cm Reinforced Steel Deck SP Mower KC711 KC711.X...
-
Page 3: Table Of Contents
Customer Service Team for assistance. We are confident you will enjoy working with your Kress product for years to come. INTENDED USE... -
Page 5: Component List
COMPONENT LIST OPERATING BAIL (BLADE ENGAGEMENT) SELF-PROPEL ENGAGEMENT BAIL UPPER HANDLE LOWER HANDLE HANDLE FASTENERS CABLE CLIP GRASS COLLECTION BAG FOLDING SWITCH SAFETY FLAP HANDLE HEIGHT ADJUSTMENT KNOB REAR WHEEL AIR FILTER BATTERY COMPARTMENT COVER FRONT WHEEL MOTOR GUARD BLADE SPACER BLADE BOLT BATTRY PACK*... -
Page 6: Product Safety
personal injury. PRODUCT SAFETY b) Use personal protective equipment. Always GENERAL POWER TOOL wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or SAFETY WARNINGS hearing protection used for appropriate conditions will reduce personal injuries. c) Prevent unintentional starting. - Page 7 g) Use the power tool, accessories and tool bits b) Thoroughly inspect the area for wildlife where etc. in accordance with these instructions, the lawnmower is to be used. Wildlife may be taking into account the working conditions and injured by the lawnmower during operation. the work to be performed.
- Page 8 Recharge only with the charger specified by manual Kress. Do not use any charger other than that specifically provided for use with the equipment. l) Do not use any battery pack which is not Warning designed for use with the equipment.
-
Page 9: Assembly & Operation
ASSEMBLY & OPERATION Remove battery from the socket before carrying out NOTE: Before using the tool, read the any adjustment, servicing or instruction book carefully. maintenance Batteries may enter water BEFORE OPERATION: cycle if disposed improperly, which can be hazardous for Adjusting handle’s height and assembling ecosystem. - Page 10 Assembling the grass collection bag (See Fig. B) Assembling the upper handle. (See Fig. A4) Assembling the grass collection bag to the lawn mower(See Fig. C,D1,D2) NOTE: Depress the grass collection bag slightly to ensure that it is completely installed. NOTE: Take the mulching plug out of the lawn mower before fitting the grass collection bag.
- Page 11 2. Keep pressing the on/off switch and the battery indicator (a ) and cutting speed indicator (c) become lit. 3. Press the cutting blade start button and pull the operatng bail to start the machine. 4. If the warning indicator (d) lights up or is flashing, refer to Troubleshooting for solutions.
- Page 12 OPERATION: Starting & Stopping the mower (See Fig. H) 1. Press the on/off switch 2. Press the cutting blade start button (Hold Down) and pull the operating bail to start the machine. 3. Release the operatng bail to stop. WARNING! The blade continues to rotate after the mower has been switched off;...
-
Page 13: Transportation
housing free of built-up grass. From time to time turn off mower and wait for the blades to come to a complete stop. Remove the batteries and turn mower on its side. Using an object such as a stick, wipe out any accumulation of grass around the blade area. -
Page 14: Maintenance
MAINTENANCE WARNING! Stop the mower and remove the battery before removing the grass collection bag. NOTE: To ensure long and reliable service, perform the following maintenance procedures regularly. Check for obvious defects such as a loose, dislodged or a damaged blade, loose fittings, and worn or damaged components. -
Page 15: Cleaning
better using experience. BLADE FUNCTION Low lift blade For extended run time Medium-lift blade Multi-purpose Recommended for High-lift blade bagging Recommended for Gator blade mulching CLEANING 1. Stop the mower and remove the battery. 2. Do not use aggressive detergents or solvents. Cleaning the air filter (See Fig. -
Page 16: Storage
STORAGE 1. Stop the mower and remove the battery. 2. Clean the exterior of the machine thoroughly using a soft brush and cloth. Do not use solvents or polishes. Remove all grass and debris, especially from the ventilation slots, mulching plate, blade area and the wheels. 3. -
Page 17: Technical Data
5. Mower is abnormally noisy and A. Release operating bail to turn mower off. Remove the vibrates. battery. Turn mower on side and check blade to ensure it has not been bent or damaged. If blade is damaged, replace with a replacement blade. - Page 18 Machine weight (bare tool) 42 kg ** X=1-999,A-Z,M1-M9 they are only used for different customers, there are no safe relevant changes between these models. *** Voltage measured without workload. Initial battery voltage reaches maximum of 60 volts. Nominal voltage is 54 volts. **** Run time may vary depending on how the tool is used and grass conditions.The selected cutting speed level affects the battery’s runtime.
- Page 20 Copyright © 2023, Positec. All Rights Reserved. AR01719600...
Need help?
Do you have a question about the KC711 Series and is the answer not in the manual?
Questions and answers