Grundig FineArts 55 FLE 9170 SP Manual page 72

speCiAl­settinGs
user­mode
You can adjust the alignment of the satellite an-
tenna to each individual satellite. These settings
will be saved so that the antenna can later be
easily guided to each saved alignment.
1 Select the line »User mode« with »
or » « and press »oK« to confirm.
Λ
– T he »USER MODE« menu appears.
2 Select the preferred option with »
or » «.
Λ
– » Satellite«: »Press oK«, select a satellite
< >
with » «, » «, »
»oK« to confirm.
– » Transponder«: »Press oK«, select the
transponder from which the signal is being
r eceived with »
press »oK« to confirm.
– » Moving Mode«: Use »
the option »Discrete« or »Continuous«.
– » Discrete«: Moves the antenna in
d efined steps to the west and the east.
– » Continuous«: Moves the antenna to the
west or east continuously.
– » Step Size«: Use »
number of steps with which the antenna
should turn. »Step Size« is only active
when the »Transport Mode« was set to
»Discrete«.
– » Move Motor«: Aligns the antenna with
the selected satellite. Use »
>
»West«, use »
– » Go To Stored Position«: Aligns the antenna
to a saved satellite position. Up to 50 posi-
tions can be saved. »Press oK« and then
select the saved position with »
Press » « (green) to confirm – the anten-

na will be aligned with the saved position.
– » Store Stored Position«: The current anten-
na alignment is saved.
3 Press »menu« to end the setting.
­ 7 2
ENGLISH
­ - ---------------------------------------------------------------------------------------------------------
« or » « and press
v Λ
< >
«, » «, » « or » « and
v Λ
< >
« or » « to select
< >
« or » « to select the
<
« to align it to
« to align it to »East«.
<
« or »
expert­mode
You can restrict the antenna's range or reset
the antenna.
1 Select the line »Installer Mode« with »
» « and press »oK« to confirm.
Λ
«
– T he »INSTALLER MODE« menu appears.
v
2 Select the preferred option with »
or » «.
Λ
« – » Limit Position«: Defines the range in
v
which the antenna may move. Use »
to set the western limit, use »
eastern limit.
– » Move Motor«: Aligns the antenna with
the selected satellite. Use »
antenna to »west«, use »
antenna to »east«.
– » Go To Stored Position«: Press »oK« to
save the current antenna alignment.
– » Store Stored Position«: Aligns the antenna
with the reference point of the positioner.
– » Reset DiSEqC 1.2 Limit«: Resets the limit
position of the antenna.
>
«.
« or
v
«
v
<
«
>
« to set the
<
« to align the
>
« to align the