Step
Screw (quantity)
1
M2 × L4.5 mm, flat-head, nylon-coated (6)
When installing: Align the connector of the built-battery with the key in the slot. Then, insert the battery into
the slot at an angle of about 35 degrees and pivot the battery downwards. Press the battery connector and
tighten screws to secure built-in battery assembly.
1030 M.2 SSD, bracket, and thermal pad
For access, remove this FRU:
• "1010 Base cover assembly" on page 67
Attention:
• Do not drop the drive or apply any physical shock to it. The drive is sensitive to physical shock. Improper
handling can cause damage and permanent loss of data.
• Before removing the drive, have the user make a backup copy of all the information on it if possible.
• Never remove the drive while the system is operating or in sleep mode.
Removal steps of M.2 SSD, SSD bracket and thermal pad
Color
Torque
0.181 Nm
Silver
(1.85 kgf-cm)
.
Chapter 9
Removing or replacing a FRU
69