Advertisement
Installation
Unpackaging and positioning
• Do not use sharp or pointed objects to unpack this appliance.
• When unpacking the appliance, never damage the insulation material on the back
of the appliance.
• Do not tilt the appliance more than 45° or lay it on its side.
• Allow the unit to stand up right for 2 hours before start-up. The lubricant will flow
back into the compressor during this time.
• The appliance must be put on a flat, firm and dry floor or similar noncombustible
pad, do not use the packaging foam
• Do not put the appliance in a wet area.
• Do not use the appliance in a frozen area.
• The appliance may not operate properly if exposed to low ambient temperatures
for extended periods of time. This can then lead to an increase in temperature
inside the appliance. Lowest ambient temperature that the appliamces can be
stored is +5°C
• Do not use the appliance in an outdoor area.
• Avoid direct sunlight.
• Please ensure that a 5mm space is allowed on either side of the appliance.
• If the appliance is being fitted up against a wall or with a 90° turn in a kitchen
please allow suffient space for the door to open 130°, allowing for the handle,
in order for the shelves and the wine to be put in and out of the wine cooler
comfortably.
This appliance is designed to be either built under counter or as a stand alone
product on the floor.
Dimensions for built under counter installation:
Wine bottles can be placed in the appliance after 1 hour of operation.
pad.柜结构及安装示意图
7
Advertisement
