Table of Contents
Advertisement
www.Toro.com to view specifications on your mower
model.
Important:
If you are using this machine above
1500 m (5,000 ft) for a continuous period, ensure
that the High Altitude Kit has been installed
so that the engine meets CARB/EPA emission
regulations. The High Altitude Kit increases
engine performance while preventing spark-plug
fouling, hard starting, and increased emissions.
Once you have installed the kit, attach the
high-altitude label next to the serial decal on the
machine. Contact any Authorized Toro Service
Dealer to obtain the proper High Altitude Kit and
high-altitude label for your machine. To locate
a dealer convenient to you, access our website
at www.Toro.com or contact our Toro Customer
Care Department at the number(s) listed in your
Emission Control Warranty Statement.
Remove the kit from the engine and restore the
engine to its original factory configuration when
running the engine under 1500 m (5,000 ft). Do
not operate an engine that has been converted
for high-altitude use at lower altitudes; otherwise,
you could overheat and damage the engine.
If you are unsure whether or not your machine has
been converted for high-altitude use, look for the
following label
(Figure
Contents
Introduction ............................................................... 1
Safety ....................................................................... 3
General Safety ................................................... 3
Safety and Instructional Decals .......................... 4
Setup ........................................................................ 5
1 Unfolding the Handle ....................................... 5
Rope Guide..................................................... 6
3 Filling the Engine with Oil ................................. 6
4 Assembling the Grass Bag............................... 7
Product Overview ..................................................... 8
Operation .................................................................. 9
Before Operation ................................................... 9
Before Operation Safety ..................................... 9
Filling the Fuel Tank ............................................ 9
Checking the Engine-Oil Level.......................... 10
3).
Figure 3
Adjusting the Handle Height ............................. 10
Adjusting the Cutting Height ..............................11
During Operation ..................................................11
During Operating Safety ....................................11
Starting the Engine ........................................... 12
Using the Self-Propel Drive............................... 12
Shutting Off the Engine..................................... 12
Recycling the Clippings .................................... 12
Bagging the Clippings....................................... 13
Operating the Bag-on-Demand Lever ............... 13
Side-Discharging the Clippings......................... 14
Operating Tips ................................................. 15
After Operation .................................................... 15
After Operating Safety ...................................... 15
Cleaning under the Machine ............................. 15
Folding the Handle ........................................... 16
Maintenance ........................................................... 17
Recommended Maintenance Schedule(s) ........... 17
Maintenance Safety.......................................... 17
Preparing for Maintenance ............................... 17
Servicing the Air Filter....................................... 18
Changing the Engine Oil ................................... 18
Replacing the Blade.......................................... 19
Adjusting the Self-Propel Drive ......................... 20
Storage ................................................................... 21
Preparing the Machine for Storage ................... 21
Removing the Machine from Storage ................ 21
decal127-9363
2
Advertisement
Table of Contents
