Technical Specifications - Bosch CTL636EB1 Instruction Manual

en
Problem
Display shows
"Refill with still water
or remove filter"
Display shows
"Empty drip trays"
despite them being empty�
Display screen reads
"Insert drip trays" even
though drip tray in use�
Water dripped onto the inner
floor of the appliance when
the drip tray was removed�
Display shows
"EXXX
please press on/off"
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.

Technical specifications

Power connection (voltage – frequency)
Heater wattage
Maximum static pump pressure
Maximum water tank capacity (without filter)
Maximum capacity of the coffee bean container
Length of power cable
Dimensions (H x B x D)
Weight, empty
Type of grinding unit
Cause
Water tank wrongly inserted
Carbonated water in the water
tank�
Float is stuck in the water
tank�
New water filter not rinsed
according to instructions, or
water filter used or defective.
Air in the water filter.
Drip tray is soiled and wet�
Inside of appliance
(tray holder) dirty�
Drip tray was removed too
soon�
Appliance is too warm�
Dirty brewing unit�
Solution
Insert water tank correctly
Fill the water tank with fresh
tap water�
Remove the tank and clean
thoroughly�
Rinse the water filter
according to the instructions
and then switch on, or use
a new water filter.
Dip the water filter into water
until no more air bubbles
escape, replace the filter.
Clean and dry the drip tray
thoroughly�
Clean the inside�
Wait a few seconds after
the last drink was dispensed
before removing the drip tray�
Leave the appliance to
cool down�
Clean the brewing unit�
220-240 V – 50/60 Hz
1600 W
19 bar
2�4 l
500 g
1�7 m
455 x 495 x 375 mm
19-20 kg
Ceramic
CTL636E.. | 07/2014
59