¡ Do not mix detergent and fabric
softener
¡ Do not use products that have ex-
pired or are highly congealed
¡ do not use products containing
solvents, caustic agents or volatile
substances
¡ Use dyes sparingly as salt may
damage stainless steel
¡ Do not use color-bleaching agents
in the appliance
operation
14 Basic operation
operation
14.1 Switching on the appli-
ance
Requirement: The appliance has
been correctly installed and connec-
ted.
→ "Installation and connection",
Page 12
Press
.
▶
The switch-on process takes a few
seconds.
Note: The lighting for the drum goes
out automatically.
14.2 Setting a programme
Turn the programme selector and
1.
set the required programme.
→ "Programmes", Page 26
If required, adjust the programme
2.
settings.
→ "Adjusting the programme set-
tings", Page 31
14.3 Adjusting the pro-
gramme settings
Requirement: A programme is set.
→ "Setting a programme", Page 31
Adjust the programme settings.
▶
→ "Buttons", Page 22
Observe the information about op-
erating logic → Page 18.
Note: The programme settings are
not saved permanently for the pro-
gramme.
14.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→ "Setting a programme",
Page 31
¡ The programme settings have
been adjusted.
→ "Adjusting the programme set-
tings", Page 31
Press and hold
▶
seconds.
Press
to call up the saved pro-
gramme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
14.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 26
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 30
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
operation en
for approx. 3
31