ASROCK Z590 PHANTOM GAMING 4 User Manual page 30

USB 3.2 Gen1 Headers
Vertical:
(19-pin USB3_3_4)
(see p.7, No. 11)
Right-Angle:
(19-pin USB3_5_6)
(see p.7, No. 14)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.7, No. 27)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
22
Vbus
IntA_PA_SSRX-
IntA_PA_SSRX+
GND
IntA_PA_SSTX-
IntA_PA_SSTX+
GND
IntA_PA_D-
IntA_PA_D+
Dummy
IntA_PB_D+
IntA_PB_D-
GND
IntA_PB_SSTX+
IntA_PB_SSTX-
GND
IntA_PB_SSRX+
IntA_PB_SSRX-
V Vbus
GND
1
MIC2_L
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
There are two USB 3.2
Vbus Vbus
IntA_PB_SSRX-
Gen1 headers on this
IntA_PB_SSRX+
motherboard. Each USB 3.2
GND
IntA_PB_SSTX-
Gen1 header can support
IntA_PB_SSTX+
GND
two ports.
IntA_PB_D-
IntA_PB_D+
Dummy
1
1
IntA_PA_D+
IntA_PA_D-
GND
IntA_PA_SSTX+
IntA_PA_SSTX-
GND
IntA_PA_SSRX+
IntA_PA_SSRX-
Vbus
This header is for
PRESENCE#
MIC_RET
connecting audio devices
OUT_RET
to the front audio panel.
OUT2_L
J_SENSE
OUT2_R
MIC2_R