Table of Contents
Advertisement
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED. DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND
UNDERSTAND THE ENTIRE INSTRUCTION MANUAL
FEET
1. Place the Router / Shaper upside down on a flat
surface.
2. Insert the coned end of the foot (A) Fig. 4, into the
square opening in the base, in the four loactions (B) as
shown.
3. Push down on the rubber feet until they are set in the
squared opening.
SPINDLE RAISING AND
LOWERING HANDLE
1. Assemble handle (A) Fig. 5, to shaft (B) making sure
the flat on inside of handle lines up with flat on shaft.
2. Fasten handle (A) Fig. 5, to shaft using a M6x1x8mm
set screw (C), with the 3mm hex wrench supplied.
OVERHEAD CUTTER GUARD
BRACKET
Assemble the overhead cutter guard holding bracket (A)
Fig. 6, to the rear of the Router/Shaper and fasten with
the two M6x10mm cheese head screws (B).
ASSEMBLY
7
Get other manuals https://www.bkmanuals.com
A
B
Fig. 4
A
B
Fig. 5
B
Fig. 6
B
C
B
A
Advertisement
Table of Contents
