Table of Contents
Advertisement
Slide the measuring aid forwards.
2.
Fold the measuring aid down and
3.
click it into place.
Push in the detergent drawer.
4.
13.8 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.9 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 31
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.10 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press
To resume the programme, after
3.
the desired soaking time, press
.
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
operation en
.
33
Advertisement
Table of Contents
