Indesit IDL 550 Instruction Booklet page 3

Connecting the water outlet hose
Connect the outlet hose (without bending it) to a drain
duct with a minimum diameter of 4 cm. Alternatively,
rest it over a sink or tub; the free end of the hose
should not remain immersed in water.
A
and 100 cm above the ground ( see figure ).
 We advise against the use of hose extensions.
Electrical connection
Before inserting the plug into the electrical socket,
make sure that:
• the socket is earthed and complies with current
regulations;
• the socket can withstand the maximum load of the
appliance, which is indicated on the data plate
located on the inside of the door ( see Description
of the appliance );
• the power supply voltage falls within the values
indicated on the data plate on the inside of the
door;
• the socket is compatible with the plug of the
appliance. If this is not the case, ask an authorised
technician to replace the plug ( see Assistance ); do
not use extension cables or multiple sockets.
 Once the appliance has been installed, the power
supply cable and the electrical socket should be
easily accessible.
 The cable should not be bent or compressed.
 The cable should be checked regularly and replaced
by authorised technicians only ( see Assistance ).
 The Company shall not be held responsible for any
incidents that occur if these regulations are not
observed.
The special plastic
elbow* makes it easier
to find the best layout:
fix the elbow to the wall
securely in order to
prevent the outlet hose
from moving and spilling
the dirty water.
The part of the hose
marked with the letter A
should be between 40
Advice regarding the first wash cycle
After the appliance has been installed, immediately
before running the first wash cycle, completely fill the
salt dispenser with water and add approximately 2 kg
of salt ( see Rinse aid and refined salt ). The water may
overflow: this is normal and is not a cause for concern.
It is also normal that the LOW SALT* indicator light
continues to flash for a few cycles after the salt has
been loaded.
Technical data
width 60 cm
Dimensions height 85 cm
depth 60 cm
Capacity
12 standard place-settings
Water supply 30 Kpa ÷ 1Mpa (0.3 ÷ 10 bar)
pressure
4.3 psi – 145 psi
Power supply
See appliance data plate
voltage
Total absorbed
See appliance data plate
power
Fuse See appliance data plate
This dishwasher conforms to
the following European
Community Directives:
-73/23/EEC dated 19/02/73
(Low Voltage) and subsequent
modifications
-89/336/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent modifications
-97/17/EC (Labelling)
-2002/96/ CE
Electrical and Electronic
Equipment (WEEE)
* Only available in selected models.
EN
Waste
3