Table of Contents
Advertisement
Quick Links
P R O B L E M S O LV E D
Installation and Operation Manual
If you need a firmware upgrade, contact Broadcast Tools®
No part of this document may be reproduced or distributed without permission.
ALL SPECIFICATIONS AND FEATURES FOR THIS PRODUCT ARE SUBJECT TO
NOTE: We recommend the use of Chrome, Firefox or Safari as your browser.
Due to the dynamic nature of product design, the information contained in this
document is subject to change without notice. Broadcast Tools, Inc., assumes no
responsibility for errors and/or omissions contained in this document. Revisions
of this information or new editions may be issued to incorporate such changes.
Broadcast Tools® is a registered trademark of Broadcast Tools, Inc.
All Sentinel® labeled products are registered trademarks of Broadcast Tools, Inc.
Copyright® 1989 - 2017 by Broadcast Tools, Inc. All rights reserved.
No part of this document may be reproduced or distributed without permission.
Visit www.broadcasttools.com for important product update information.
COP-2/RJ
Connect O' Pad 2/RJ
Manual update: 11/21/17
CHANGE WITHOUT NOTICE
®
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Broadcast Tools COP-2/RJ
Summary of Contents for Broadcast Tools COP-2/RJ
- Page 1 NOTE: We recommend the use of Chrome, Firefox or Safari as your browser. Due to the dynamic nature of product design, the information contained in this document is subject to change without notice. Broadcast Tools, Inc., assumes no responsibility for errors and/or omissions contained in this document. Revisions of this information or new editions may be issued to incorporate such changes.
- Page 2 COP-2/RJ Installation and Operation Manual INTRODUCTION CAUTION! Thank you for your purchase of a Broadcast Tools® COP-2/RJ, Connect O’ Pad. We are confident that this product will give you many years of dependable serv- Broadcast Tools® ice. This manual is intended to give you all the information needed to install the Products, as with any Broadcast Tools®...
- Page 3 2/RJ is designed to plug into the male 9-pin D-Sub connector on the audio modules of the listed receivers. The COP-2/RJ is equipped with a shielded RJ45 output jack for connection to the balanced analog audio left and right outputs or one AES out- put (switch selectable.) Left and right multi-turn trimmers are provided for analog...
- Page 4 Step 1: Set the SW-1 switch for AES or Analog, depending on which format you wish to use. Step 2: Plug the COP-2/RJ into the desired “Audio x” (x = port)) connector on the rear panel. For the IDC WW1-MAX/IDC SFX Pro (NON-option B) receivers, plug the COP-2/RJ into the desired “Audio Channel x”...
- Page 5 If Broadcast Tools is notified, in writing, of a failure of any item manufactured by Broadcast Tools to conform to the foregoing Limited Warranty within one (1) year following the date of the Buyer’s acquisition of the item, and if the item is returned to Broadcast Tools in accordance with Broadcast Tools’...
- Page 6 Product_Name Installation and Operation Manual APPENDIX e-mail: voice: fax: support@broadcasttools.com 360.854.9559 866.783.1742...
Need help?
Do you have a question about the COP-2/RJ and is the answer not in the manual?
Questions and answers