Table of Contents
Advertisement
3 Check whether the option values that you have set are
correct by pressing the
[SEG2, SEG3]
[SEG4, SEG5]
[SEG11 , SEG12 ]
[SEG14 , SEG15 ]
[SEG21 , SEG22]
[SEG23, SEG24]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor
on the indoor unit and then press the
button on the remote control twice. Make sure that
this command is received by the indoor unit. When it is
successfully received, you can hear a short sound from
the indoor unit. If the command is not received, press
the
(Power) button again.
5 Check whether the air conditioner operates in
accordance with the option values you have set:
a Reset the indoor unit by disconnecting and then
reconnecting the power cable of the indoor unit or
by pressing the RESET button on the outdoor unit.
b Remove the batteries from the remote control,
insert them again, and then press the
button on the remote control.
(Mode) button repeatedly
[SEG6, SEG8]
[SEG9, SEG10 ]
[SEG16 , SEG17 ]
[SEG18 , SEG20]
(Power)
(Power)
Setting the indoor unit address and installation
option
1 Make sure that the power is supplied to the indoor
unit.
• If the indoor unit is not plugged in, it must include a
power supply.
2 Make sure that the panel or display is connected to the
indoor unit so that it can receive options
Indoor unit
3 Set an address and installation option for each indoor
unit using the remote control, according to your air
conditioning system plan.
25
English
Advertisement
Table of Contents
