Quick Install Guide PXH812 Operating Modes The Dolphin PCI Express PXH812 card is a transparent PCI Express Gen3 cable adapter card. The card supports both upstream host and downstream target operation. The operation is controlled by the TRANSP and TARGET DIP switches that can be found close to the upper edge of the board.
Page 8
The MTBF (in hours) for the PXH812 can be found in the table below. The numbers are calculated using the Telcordia SR- 332 issue 2 (2006) standard. Environment Ambient Ground Ground fixed, Ground fixed, Temp [°C] controlled uncontrolled mobile 6.083.909 3.041.955...
Page 9
Use Cases Use Case A: Transparent IO Use Case B – Transparent Downstream Target...
Configuration and DIP Switches The PXH812 has DIP switches for setting special modes or operations. Please carefully read the documentation before modifying any DIP switch settings. Please pay careful attention to ON and OFF positions written on the DIP switch.
Installation Static electricity from your clothes or work environment can damage your PCI Express adapter card or your PC. Always wear a grounded anti-static wrist strap while opening the PC and when the PXH812 is removed from the anti-static bag.
Page 14
01:00.0 PCI bridge: PLX Technology, Inc. PEX 8717 16-lane, 8-Port PCI Express Gen 3 (8.0 GT/s) Switch with DMA (rev ca) 01:00.1 System peripheral: PLX Technology, Inc. Device 87d0 (rev ca) 01:00.2 System peripheral: PLX Technology, Inc. Device 87d0 (rev ca) 02:00.0 PCI bridge: PLX Technology, Inc.
Limited Warranty Dolphin Interconnect Solutions warrants this product to be free from manufacturing defects under the following terms: Warranty Period Coverage • • • • • • • • • Service Procedure Limitations...
Need help?
Do you have a question about the PXH812 and is the answer not in the manual?
Questions and answers