Thank you for choosing a Hoover dish Contents washer. We are confident it will assist you loyally in washing your daily dishes in full 1. GENERAL SAFETY RULES safety. Carefully read this manual for correct and 2. WATER CONNECTION safe appliance use and for helpful tips on 3.
1. GENERAL SAFETY capabilities or lack of experience and knowledge if they have been RULES given supervision or instruction This appliance is intended to l concerning use of the appliance be used in household and in a safe way and understand the similar applications such as: hazards involved.
Page 4
Make sure carpets or rugs do The manufacturer declines all l not obstruct the base or any of responsibility for any damage the ventilation openings. to people or property due to non-earthing of the machine. After installation, the appliance l must be positioned so that the Ensure that the dishwasher l...
Page 5
If there is a water softening l marking this product, device installed in the home we confirm, under our own there is no need to add salt to responsibility, full compliance the water softener fitted in the this product with dishwasher.
2. WATER CONNECTION l If the dishwasher is connected to new pipes The appliance must be connected to or to pipes which have not been inuse for a the water mains using new hose-sets. long time run water through for a few The old hose-sets should not be minutes before connecting the inlet hose.
Page 7
l AQUASTOP (fig. 4): Hydraulic safety devices A device located on the supply tube that stops water flow if the tube deteriorates; in this case, a red mark will appear in the All the dishwashers are equipped with window "A" and the tube must be an overflow safety device which, if replaced.
Page 8
Connecting the outlet hose l The outlet hose should disharge into a l The hose can be hooked over the side of standpipe, making sure that there are no the sink, but it must not be immersed in kinks (fig. 6). water, in order to prevent water from being syphoned back to the machine l...
3. LOADING THE SALT After loading the salt, YOU MUST run a complete washing cycle, or the (Fig. A "1") PRE-WASH/COLD RINSE/REFRESH programme. l The appearance of white stains on dishes is generally a warning sign that the salt container needs filling. l...
4. ADJUSTING THE UPPER Type "B": (ONLY MODELS WITH EASY CLICK): BASKET (ONLY ON SOME 1. Remove the upper basket; 2. Hold the basket on both sides and lift it MODELS) upwards (fig. 1). l Dishes that are greater than 20 cm* in If 29 cm to 32.5 cm plates are regularly diameter can no longer be loaded onto the used, load them onto the lower basket...
5. LOADING DISHES example of loading see fig. 1, 2 e 3. Using the upper basket Upper basket (fig. 1) l The upper basket is provided with mobile racks hooked to the sides of the basket, which can be regulated into 4 positions. l...
l Cutlery basket (fig. 6) Place the cutlery in the plastic cutlery holder with the handles pointing upwards. The cutlery basket is made with two detachable parts which will enable various l Place the cutlery holder on the lower loading options. The two parts can be basket (fig.
7. LOADING THE DETERGENT (Fig. A "2") The detergent It is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid,gel or tablet form. After pouring detergent into container, close the lid, firstly pushing (1) and then pressing on it (2) until you hear Unsuitable detergents...
l 8. TYPES OF DETERGENT read carefully and follow the manufacturer’s instructions given on the packaging; Detergent tablets l effectiveness detergents containingthe built in water softener/salt Detergent tablets of different manufacturers depends on the hardness of your water dissolve at different speeds, for this reason, supply.
9. LOADING THE RINSE AID (Fig. A "3") The rinse aid The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. Filling the rinse aid container. The rinse aid container can be found to the left of the detergent container (fig.
10. CLEANING THE FILTERS (Fig. A "4") The filter system consists of: A. A central container that traps the larger particles; B. A micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse; C. A flat gauze that continuously filters the wash water.
11. PRACTICAL HINTS to soften the food remains and remove bigger particles of food from the new load of dishes. When the dishwasher is full How to get really good wash start complete wash cycle results. programme. l Before placing dishes l...
12. CLEANING AND Do not use tools that can deform the MAINTENANCE spray heads. (Fig. A “5”) 3) when you have finished, refit the rotor l To clean the dishwasher outside, do not arms same position, use solvents (degreasing action) neither remembering to re-align the arrow and abrasives, but only a cloth soaked with screw into position.
Page 19
If the machine is not going to be used for 4. fill the rinse aid container; some time, it is advisable to follow these 5. Ieave the door ajar; rules: 6. keep the inside of the machine clean; 1. do an empty wash with detergent in order to clean the machine of any 7.
15. PROGRAMME SELECTION Next time you switch on the AND SPECIAL FEATURES appliance Hold down the ON/OFF button for about 3 ON/OFF button sec. to turn the machine on, and the “P3”programme indicator light will come on. l To turn the appliance on and off, press the ON/OFF button (for at least 3 seconds).
Page 22
l Press the "Start Delay" button to activate Open the door slowly and carefully, to the MEMO FUNCTION (refer to the avoid getting wet with splashes of appropriate chapter in the instruction washing water. booklet for information on how to turn it on and off).
Page 23
l The running programme will be cancelled If an option is selected that is not and all the programme indicator lights will flash. compatible with the selected programme then the option indicator light first flashes l At this point a new programme can be set. and then goes off.
Page 24
"START DELAY" button Activation/Muted END-OF- PROGRAMME signal. The dishwasher start time can be set with You can deactivate turning on and off of the this button, delaying the start by 3, 6 or 9 audio signal as follows (the default setting is hours.
Page 25
1. The "6h" indicator light on the "Start Turn the child lock feature on and off as Delay" function is off by default. follows: l Turn on the dishwasher by pressing the 2. When you press the "Start Delay" "ON/OFF" button for about 3 sec. button, the "6h"...
The machine is connected, and you can Pairing the machine with the app now control your machine from the app. l Download the Hoover Wizard app onto Unsuccessful enrollment your device. If enrollment fails, or does not succeed within 5 min.:...
Page 27
Alternative way to exit remote control. DISABLING REMOTE CONTROL l Press "Start/Reset" and hold down for 3 sec.: if there is a cycle under way, it will l To exit remote control, press “Progr. be cancelled, and the machine will exit 3sec WiFi”...
17. PROGRAMME LEGEND Programme Description Once a day - for heavily soiled pans and any other Intensive items that have been left all day for washing. Once a day - for normal soiled pans and any other Universal items that have been left all day for washing. Programme for normally soiled tableware (the most efficient in terms of its combined energy and water consumption for that type of tableware).
Page 29
Options Programme ● Intensive Universal ● Pre-wash ● Total Care ● = Add detergent for prewash N/A= OPTION NOT AVAILABLE 1) With cold water (15°C) – Tollerance ±10%
With hot water the time remaining until the end of the programme is automatically displayed while the programme is running.
...
18. WATER SOFTENER UNIT Depending on the source of the supply, According to the degree of hardness of your water contains varying amounts water, regulate the softener unit in the limestone and minerals which are deposited following way: on the dishes leaving whitish stains and marks.
19. TROUBLESHOOTING AND WARRANTY If you believe the dishwasher is not working correctly, consult the quick guide provided below with some practical tips on how to fix the most common problems. If the malfunction continues or recurs, contact the Technical Assistance Centre. BUG REPORTS l...
Page 32
Only models without a display If malfunctions or faults occur when a programme is running, the indicator light that corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button. After checking to make sure the water supply is open, that the drain pipe is not bent and that the siphon or filters are not clogged, set the selected program again.
Page 33
FAULTS CAUSE SOLUTION Reduce amount of detergent Use 5. Spray arms are Excessive amount of detergent suitable detergent not heard to Item prevents arms from rotating Check rotate Filtering plate and filter very dirty Clean filtering plate and filter 6. On electronic appliances without a Switch off the appliance.
Page 34
N.B.: Should any of the above situations result in a bad wash performance or insufficient rinsing, remove dirt deposits from the dishes by hand since the final drying cycle hardens the dirt, making it difficult to remove with a subsequent wash. If the malfunction continues, contact the Technical Assistance Centre, quoting the model of the dishwasher.
20. ENVIRONMENTAL CONDITIONS l This appliance marked WEEE should treated cording to the European directive household waste; 2012/19/EUon Waste Electrical l WEEE should be handed over to the Electronic Equipment (WEEE). relevant collection points managed by WEEE contains both polluting substances municipality registered (which can cause negative consequences...
Page 36
Frequency range - Max Transmit Power - Minimum Receiving Sensitivity - Magnetic field limit Candy Hoover Group Srl With this the , declares that this appliance marked with complies with the essential requirements of the Directive 2014/53/EU. To receive a copy of the declaration of conformity, please contact the manufacturer at: www.candy-group.
Need help?
Do you have a question about the HSPN 1L390PW and is the answer not in the manual?
Questions and answers