Table of Contents
Advertisement
•
Disconnect battery ground cable (−) before making
adjustments to electrical systems or before welding on
the machine.
•
Sufficiently illuminate the work site. Use a
maintenance work light when working under or inside
the machine.
•
Always use a work light protected with a guard. In
case the light bulb is broken, spilled fuel, oil, antifreeze
fluid, or window washer fluid may catch fire.
•
When the floor tilt mechanism check and/or mainte-
nance is conducted, the operator's station is tilted
upward. Before conducting maintenance work, refer to
page 7-76 in the operator's manual for the detailed
operation procedures and correctly operate the ma-
chine.
•
When required to work under the floor, support the
raised operator's station with the fall prevention bars
(red color) to ensure safety.
•
When the inspection/maintenance work is complete,
tilt the operator's station downward after housing the
fall prevention bars. Be sure to slowly lower the op-
erator's station at the time.
•
Be careful not to allow the operator's station to tilt
down without first stowing the fall prevention bars.
Damage to the tilt mechanism may result.
WARN OTHERS OF SERVICE WORK
•
Unexpected machine movement can cause serious
injury.
•
Before performing any work on the machine, attach a
"Do Not Operate" tag in an easy-to-see place such as
on the cab door or control lever.
•
Never attempt to operate the machine with a "Do Not
Operate" tag attached.
•
Make it a rule for the inspection/service person to hold
the engine start key during inspection/service work.
SAFETY
SA-22
SA-037
M1MW-07-031
SS2045102
Advertisement
Table of Contents
