Table of Contents
Advertisement
Correcting the date
Use the strap clamp's protrusion to depress the
SELECT and ADJUST buttons*
1. To select the category of digits that you want
to change, depress the SELECT button @ re¬
peatedly until the digits on the LCD panel
that you want to change begin to blink.
2. Depress the ADJUST button © to change
digits of the specified category you chose with
the SELECT button ©. Digits increase by
one each time you depress the ADJUST but¬
ton 0. Holding down the button will advance
digits continuously.
3. After the data has been adjusted, depress the
SELECT button © until blinking stops. The
bar mark (-) appears on the LCD panel, indi¬
cating that data imprinting choices are possi¬
ble.
• The blinking
allows precise fine-tuning of
the internal clock to the beginning of a speci¬
fied minute. To do so, depress the mode but¬
ton
O
until
"Day-Hour-Minute"
digits
appear and then depress the SELECT button
© to make the
blink. Then depress the
adjust button © in sync with a time signal.
• If you release the shutter while the blinking
data is being corrected, the data cannot be
imprinted.
Operational precautions
• As you release the shutter, the bar( - ) mark
on the display blinks for a few seconds, indi¬
cating the data has been imprinted.
• If there is a white or yellow object in the cor¬
ner of the picture where the data is im¬
printed, the data may be difficult to read.
When composing your photographs, try to
avoid brightly-colored subjects in that cor¬
ner.
* The date in the picture above is
simulated.
27
Advertisement
Table of Contents
