Removal; Replacement; 3202 - Operator Panel And Status/Control Panel Removal - Seagate ST8741J Maintenance Manual

I
3202 - Operator Panel and Status/Control Panel Removal
&
Replacement
3202 - OPERATOR PANEL AND STATUS/CONTROL PANEL REMOVAL &
REPLACEMENT
The mounting location for either the operator panel or the
status/control panel is behind the front panel insert. The
panels have no replaceable parts but must be replaced as
assemblies.
REMOVAL
1. Remove front panel insert from each drive (see figure
3-5).
NOTE
The release latch on the left-hand drive locks
the 2X drawer in the rack. The release latch
on the right-hand drive has no function.
2. Push 2X drawer release latch to the right and extend 2X
drawer to gain access to On/Standby switch on power
supply.
3. Remove power from drive as follows:
4.
3-18
a. Press START switch to stop the drive.
b. Wait for Ready indicator (on START switch) to stop
flashing; then, set On/Standby switch on power supply
to Standby position.
Complete the removal procedure as follows:
• For drives with status/control panel:
a. Remove screws securing status/control panel to
front panel.
b. Disconnect jumper cable from Pl3 while removing
status/control panel from front panel.
• For drives with operator panel:
a. Remove screws securing operator panel to shield and
remove operator panel.
b. Disconnect jumper cable from Pl3 on opP.rator panel.
c. Remove screws securing shield to front panel and
remove shield.
REPAIR AND REPLACEMENT
83325720 E