Advertisement
Standard Installation
LED Installation - If Required
1. Loosen #8-32 stainless steel set screw on cap using a
5/64" Allen wrench and remove.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
B-K LIGHTING
Litestick, Litestick Style L, Litestick Style T
2. For BKSSL: Pull the heat sink from the body to expose
the LED board and Driver components. Utilize quick
disconnects to change modular LED and driver
components. Re-install the heat sink into body.
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • info@bklighting.com
3. Place cap on fixture and tighten set screw. Tighten
screw to 1/2 inch pounds. Top of screw should sit flush
with fixture cap.
Warning: Do not over tighten set screw. Doing so
will compromise o-ring seal and will void warranty.
RELEASE DATE
08/02/2023
LED
REFERENCE NUMBER
INS001109
Advertisement
