Toshiba Satellite M50-04N01N Resource Manual page 36

36
Setting up your computer and getting started
17 Reconnect any cables.
18 Restart the computer.
Removing a memory module
1 Follow steps 1 through 8 in "Installing additional
memory (optional)" on page 32.
2 Pull the clips away from the memory module.
The memory module pops up slightly.
3 Gently lift the card to a 45-degree angle and slide the
memory module out of the slot.
4 Replace the memory module slot cover and tighten the
screw.
5 Turn the computer over and restart it.
If you use the computer for a long time, the memory module will
become hot. If this happens, let the module cool to room temperature
before you replace it.
Do not try to remove a memory module with the computer turned on.
You can damage the computer and the device.
Do not remove the memory module while the computer is in Standby
mode. The computer could hang up the next time you turn it on and
date in the memory will be lost. In either of the above cases, the
Standby configuration will not be saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any key to Continue
If the computer hangs up when you turn it on, perform the following:
Press the power button and hold it down for at least ten seconds,
then turn the power on again.
TECHNICAL NOTE: You must have at least one memory module
installed for the computer to work.