Advertisement
2
READ
INSTRUCTIONS — All
the
safety
and
Operating instructions should be read before the
appliance is operated.
RETAIN INSTRUCTIONS
— The operating instruc-
ttons should be retained for future reference.
HEED WARNING
— All warnings on the appliance
and
in the
operating
instructions
should
be
adhered to.
FOLLOW INSTRUCTIONS — All operating and use
instructions should be followed.
WATER
AND
MOISTURE — The appliance should
not be used near water
—
for example, near a
bathtub, washbow/l, kitchen sink, laundry tub, ina
wet basement, or near a swimming pool, etc.
LOCATION — The appliance should be installed in a
stable location.
WALL OR CEILING
MOUNTING
—
The appliance
should not be mounted to a wail or ceiling.
VENTILATION
— The appliance should be situated
so that its !ocation or position does not interfere
with its proper ventilation. For example, the ap-
pliance should not be situated on a bed, sofa, rug,
or similar surface that may block the ventilation
Openings: or, placed in a built-in installation, such
as a bookcase or cabinet that may impede the
flow of air through the ventilation openings.
HEAT — The appliance should be situated away from
heat sources
such
as radiators,
heat registers,
stoves, or other appliances (including amplifiers)
that produce heat.
POWER
SOURCES —The
appliance
should
be
connected
to a power supply only of the type
described
in the
operating
instructions
or as
marked on the appliance.
POWER-CORD
PROTECTION — Power-supply
cords should be routed so that they are not likely
to be walked on or pinched by items placed upon
or against them, paying
particular attention to
cords at plugs, convenience receptacles, and the
point where they exit from the appliance.
POLARIZATION — If your
purchased
product
is
provided with a polarized power plug, please read
the
following
instructions.
This
product
is
equipped with a polarized alternating current line
plug (a plug having one
blade wider than the
other). This piug will fit into the power outlet only
one way. This is a safety feature. If you are unable
to insert the plug fully into the outlet, try reversing
the plug. If the plug should still fai! to fit, contact
your electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the polarized
plug.
CLEANING — The appliance should be cleaned only
with a polishing cloth or a soft dry cloth. Never
clean with furniture wax, benzine, insecticides or
other volatile liquids since they may corrode the
cabinet.
IMPORTANT
1
The tightning flash with arrowhead, within an equi-
jateral triangle, is intended to alert the user of the
presence of uninsulated "dangerous voltage" within
the product's enclosure
that may
be of sufficient
magnitude
to constitute a risk of electric shock to
persons.
IMPORTANT
2
tf the apparatus is fitted with AC mains power out-
let(s), see REAR
PANEL FACILITIES for convenient
connection
of additional Hi-Fi component(s).
Make
all connections
to the AC
outlet(s)
and the signal
terminals first. Connect the plug to the wali socket
last, make sure that the power switch is off. Discon-
Nect the wall plug when
the equipment
is not in
(regular) use, e.g. when on vacation.
<ARE1048>
SERVICE ENTRANCE
€QUIPMENT
POWER
LINES
— An outdoor antenna should be
located away from power lines.
NONUSE
PERIODS —The
power
cord
of
the
appliance should be unplugged from the outlet
when left unused for a long period of time.
OBJECT
AND
LIQUID
ENTRY
— Care should be
taken so that objects do not fall and liquids are
not spilled into the enclosure through openings.
DAMAGE
REQUIRING SERVICE
— The appliance
should be serviced by a Pioneer authorized ser-
vice center or qualified service personnel when:
The power-supply
cord
or the plug has been
damaged: or
Objects have fallen, or tiquid has been spilled into
the appliance: or
The appliance has been exposed to rain: or
The appliance does not appear to operate nor-
mally or exhibits
a marked
change
in perfor-
mance; or
@
The appliance has been dropped; or the enclosure
damaged.
SERVICING — The
user
should
not
attempt
to
service the appliance beyond that described in the
Operating
instructions.
For all other
servicing,
contact
the nearest
Pioneer authorized
service
center.
POWER LINES
SERVICE
ENTRANCE
CONDUCTORS,
GROUND
GROUND
WIRE a,b
CLAMPS
SAFETY INSTRUCTIONS
OUTDOOR ANTENNA GROUNDING — If an out-
side antenna is connected to the antenna termi-
nai, be sure the antenna system is grounded so as
to provide some protection against voltage surges
and built up static charges.
In the U.S.A. section 810 of the National Elec-
trical Code, ANS!I/NFPA No. 70-1984, provides
information with respect to proper grounding of
the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size
of grounding conductors,
location of antenna-
discharge
unit, connection
to grounding
elec-
trodes, and requirements for the grounding elec-
trode. See Fig. A.
Use No. 10 AWG (5.3mm?%) cop-
per. No. 8 AWG (8.4 mm?) alu-
minum, No. 17 AWG (1.0 mm?)
copperclad steel, bronze wire, or
larger as ground wire.
Secure
antenna
lead-in
and
ground
wires
to
house
with
stand-off insulators spaced from
4 feet
(1.22 meters) to 6 feet
(1.83 meters) apart.
Mount antenna discharge unit as
closely as possible to where lead-
in enters house.
Use jumper wire not smaller than
No.6 AWG (13.3 mm?) copper,
or the equivalent, when
a sepa-
rate antenna-grounding electrode
is used.
See NEC Section 810-21
(j).
STAND-OFF
INSULATORS b
ANTENNA
LEAD-IN WIRE
TO EXTERNAL ANTENNA
TERMINALS OF PRODUCT
ANTENNA
DISCHARGE
UNIT c
GROUND
WIRE a.b
GROUND
POWER SERVICE
GROUNDING
ELECTRODE
SYSTEM
(e.g. interior metal water pipe)
eg)
==
CLAMPS
OPTIONAL ANTENNA
GROUNDING
ELECTRODE
DRIVEN 8 FEET (2.44 m)
BONDING
JUMPER d
(INTO THE EARTH
iF REQUIRED BY
LOCAi CODES SEE
NEC SECTION 810.21
(f).
CAUTION
RISK OF ELECTRIC SHOCK
®O NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK,
DO
NOT
REMOVE
COVER
(OR
BACK).
NO
USER-SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING
TO
QUALIFIED
SERVICE
PERSONNEL,
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured in accor-
dance with the following code:
Biue:
Neutral
Brown:
Live
The exclamation point within an equilaterd tr tangle is
intended to alert the user of the presence ¢ inmportant
operating and maintenance (servicing) insrucctions in
the literature accompanying the appliance
As the colours of the wires in the mains 2acd of this
apparatus
may
not correspond
with
th: coloured
marking identifying the terminals in your plig proceed
as follows:
The wire which is coloured blue must be Cmn ected to
the terminal
which
is marked
with
the ktrer
N or
coloured black.
The wire which is coloured brown must beso mnected
to the terminal which is marked with theler ter L or
coloured red.
Equipment sold in the U.K. is not supjieed with
a power
plug.
Advertisement
