Advertisement
nstallation and setup guide
2
WBM Link to NMEA 2000
4
1.
Introduction
The WBM Link to NMEA 2000 interface forms a bridge between WBM Link
enabled devices and an NMEA 2000 network. Currently it only supports the
WBM Modular Smart Shunt ba�ery monitor.
The interface presents the following parameters on the NMEA 2000 network.
unting screws
Only the parameters of ba�ery bank 1 are available.
Changing of device- and ba�ery instance is fully supported by this interface,
allowing multiple WBM Modular Smart Shunt on the NMEA 2000 network, with
each WBM Modular Smart Shunt having its own WBM Link to NMEA 2000
interface. A proper NMEA 2000 network management tool is needed to change
device- and ba�ery instance. Such a tool is not provided by us.
It is assumed that the user of this device has a good understanding of the NMEA
2000 standard.
5
The NMEA 2000 standard contains the requirements of a serial data
communica ons network to inter-connect marine electronic equipment on
vessels. It is mul -master and self-configuring, and there is no central network
controller. Equipment designed to this standard will have the ability to share data,
including commands and status with other compa ble equipment over a single
channel. It is based on CAN (Controller Area Network). NMEA 2000 is a registered
Trademark of the Na onal Marine Electronics Associa on.
Introduction
Voltage
§
Current
§
Amp-Hours removed
§
State-of-Charge
§
Time Remaining
§
Temperature
§
Ba�ery Capacity
§
Ba�ery Type
§
Nominal Voltage
§
NMEA 2000 Interface Standard
Advertisement
