Equipment Setting And Checking - Inter-m ER-6116 Operation Manual

EMERGENCY ROUTER

Equipment Setting and Checking

Equipment Setting and Checking
1. Address Switch Setting
- Set the equipment numbers for each deciding condition using the rear panel DIP switch.
- If the equipment number is not set-up or is incorrect, all Zone Indicator LEDs will blink.
- If the number is already in-use, the system will not function properly.
- Please check the equipment number set-up status.
The table below shows the setting methods; the ON switch setting/number will be the equipment number.
DIP Switch
1
2
Address 3
10
2. TERMINATION Switch (LOAD/OPEN) Setting
1) For the system linked by using RS-485 communication interface, it is necessary to set the termination
switch (LOAD/OPEN) on the rear panel to stabilize data transfer.
2) Set the termination switch to LOAD only for the first and last-numbered equipment units. All others must be
set to OPEN.
Equipment 1
S/W: LOAD
OUT
※ Caution: Communication error may occur if setting is performed incorrectly.
3. Adding sound sources to VIOCE FILE (PV-6232)
1) Only available as MP3 file
2) General Scenario Sound Source
A) 1~99 track can be used as the scenario sound source among sound sources saved in PV-6232.
B) To save the sound source in PV-6232
- Add 001~099 in front of file name to be used as the sound source in PC to properly archive/indicate
each track's number.
4 ER-6116
1 2 3 4
ON
ON
ON
Equipment 2
S/W: OPEN
IN OUT
5 6 7
Equipment 3
S/W: OPEN
IN OUT IN
8 9 10
ON
Equipment N
S/W: LOAD