Cleaning Under The Machine - Toro eTimeMaster 21491 Operator's Manual

3. Slide the battery pack into the charger until it is
fully seated (Figure
4. To remove the battery pack, slide the battery
backward out of the charger.
5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator Indicates
light
Off No battery pack inserted
Green Battery pack is charging
blinking
Green Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red Battery pack charging fault*
blinking
*Refer to Specifications (page 11)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page 25).
Cleaning Under the
Machine
Service Interval: After each use
WARNING
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with a blade or thrown
debris can cause injury or death.
• Replace a broken or missing washout
fitting immediately, before using the
machine again.
• Never put your hands or feet under the
machine or through openings in the
machine.
1. Move the machine to a level surface.
2. Shut off the machine and wait for all moving
parts to stop before leaving the operating
position.
3. Lower the machine to its lowest cutting-height
setting. Refer to
(page 13).
4. Attach a hose to the washout fitting, and turn the
water on high (Figure
20).
for more
Adjusting the Cutting Height
21).
Note:
Spread petroleum jelly on the washout
fitting O-ring to make the coupling slide on
easier and protect the O-ring.
1. Washout fitting
2. Hose
5. Start the machine, engage the blade-control
lever, and let the machine run for 1 to 3 minutes
with the blades turning.
6. Disengage the blade-control lever, shut off the
machine, and wait for all moving parts to stop.
7. Shut off the water and remove the coupling from
the washout fitting.
Note:
If the machine is not clean after a single
washing, soak it and let it stand for 30 minutes.
Then repeat the process.
8. Run the machine again and engage the blades
for 1 to 3 minutes to remove the excess water.
19
Figure 21
3. O-ring
4. Coupling
g003934