Adjusting The Handle Height; Adjusting The Cutting Height - Toro eTimeMaster 21491 Operator's Manual

Adjusting the Handle Height

You may raise or lower the handle to a position comfortable for you.
Pull the handle-lock lever rearward to disengage the handle-lock pins, move the handle to 1 of 4 positions, and
release the handle-lock lever to secure the handle in place.

Adjusting the Cutting Height

DANGER
Adjusting the height-of-cut could bring your hands into contact with a moving blade and
result in serious injury.
• Shut off the motor, remove the battery, and wait for all moving parts to stop before adjusting
the cutting height.
• Do not put your fingers under the housing when adjusting the cutting height.
Note:
To raise the machine, move the front and rear cutting-height levers forward; to lower the machine,
move the cutting-height levers rearward. Set all the wheels to the same height unless special circumstances
require otherwise.
(Figure 11).
Figure 11
Figure 12
13
g426209
g426213